Deutz-Fahr 914 – ECU: DEF Supply Module Heater Plausibility Error
Issue description
The Engine Control Unit (ECU) has detected that the temperature data from the Diesel Exhaust Fluid (DEF) supply module heater is erratic, intermittent, or incorrect. This plausibility error means the sensor readings are not logical under current operating conditions (e.g., reporting high temperature at cold start). This prevents the Selective Catalytic Reduction (SCR) system from functioning correctly, which can lead to increased emissions and potential engine power reduction.
Applies to these machines
3 machines- TCD 2.9
- TCD 4.1
- TCD 2013
Check the cause
Cycle the ignition off, wait up to 2 minutes for the ECU to fully power down, and restart the engine to verify if the fault is still active
Visually inspect the wiring harness and connectors leading to the DEF supply module for damage, corrosion, chafing, or loose connections
Check DEF quality using a refractometer; the urea concentration should be between 31.8% and 33.2% and the fluid should be crystal clear
Verify the heater circuit is receiving the correct voltage from the ECU or relay when activated and has a solid ground connection
Measure the signal from the temperature sensor back to the ECU to ensure voltage or resistance changes with temperature (checking for open circuits)
Test for short circuits between the signal wire and power or ground
Repair steps
Isolate the fault
Based on the electrical and visual diagnostic checks, determine if the fault lies with the wiring, the connections, or the DEF supply module itself.
Repair wiring and connections
If any damaged wiring or corroded connectors are found, repair or replace them. Ensure all connections are clean, tight, and secure.
Replace DEF supply module
If the wiring and connections are confirmed to be in good condition, the fault is likely internal. Replace the entire DEF supply module, as the heater and temperature sensor are integrated and not serviced separately.
Clear fault codes
After the repair is complete, use a compatible diagnostic tool (such as Deutz SerDia) to clear the fault code from the ECU's memory.
Perform system test
Run the engine and initiate a system test with the diagnostic tool to verify that the SCR system and its heater are functioning correctly and the fault does not return.
Parts you might need
(3)DEF Supply Module
04603859OEM Deutz part. Superseded by 04609000.
- DEF Supply Module04609000
OEM Deutz part. Supersedes 04603859.
DEF Supply Module
044404229ZBosch OEM equivalent part number.
Get help to fix this fault by requesting a quote