Deutz-Fahr 914 – ECU: AdBlue Heater Temperature Signal Implausible
Issue description
The Engine Control Unit (ECU) has detected a plausibility error regarding the temperature of the AdBlue supply module's heater. This indicates that while the temperature sensor is providing a signal, the reported value is not logical under current operating conditions (e.g., heating too quickly, too slowly, or not changing when activated). The heater is critical for thawing and maintaining AdBlue fluid above its freezing point (-11°C/12°F) to ensure proper dosing into the exhaust stream.
Applies to these machines
4 machines- Deutz TCD 3.6 L4
- Deutz TCD 4.1
- Deutz TCD 6.1
- Deutz 4-16L TDI (EDC17CV5x)
Check the cause
Inspect the wiring harness and connectors at the AdBlue supply module for water ingress, corrosion (green crust), or backed-out pins.
Inspect the wiring loom leading to the supply module for chafing, rubbing, or heat damage that could cause a short or intermittent connection.
Check AdBlue quality and level, looking for heavy crystallization around the tank module which can indicate prolonged heating system issues.
Verify the heater circuit at the supply module connector is receiving correct battery voltage and a solid ground when commanded on (voltage drop under load indicates a poor connection).
Measure resistance across the heater element's terminals (typically 1-10 ohms). An open circuit indicates a broken element, while near zero ohms suggests a short circuit.
Monitor 'AdBlue Supply Module Temperature' live data with a diagnostic tool. Compare the reading to ambient temperature when cold; if it reads an illogical value (e.g., -40°C or 120°C) or does not change when activated, the sensor is faulty.
Repair steps
Depressurize and drain system
Follow manufacturer guidelines to safely depressurize the AdBlue system. Drain the AdBlue tank if necessary to minimize spillage.
Disconnect lines and wiring
Carefully disconnect the main electrical connector from the supply module. Disconnect the AdBlue lines, noting their positions, and prepare for residual fluid leakage.
Remove old supply module
Remove the locking ring or bolts securing the supply module to the AdBlue tank and carefully lift the module out of the tank.
Install new supply module
Clean the mounting surface on the tank. Install the new module, ensuring seals or gaskets are correctly positioned, and tighten fasteners to the manufacturer's specified torque.
Reconnect Lines and Electrical Connector
Reconnect the AdBlue fluid lines and the electrical harness connector, ensuring they click into place securely.
Refill and Prime
Refill the AdBlue tank with fresh, high-quality fluid.
Clear Fault Codes and Test
Using a diagnostic tool, clear the fault code 914 / 523720 FMI 2 from the ECU memory. Start the engine and allow the system to run its self-tests. Monitor live data to ensure the new heater is functioning and the temperature is rising as expected. Perform a road test or operate the machine to confirm the fault does not return.
Parts you might need
(8)AdBlue Supply Module (Bosch 0444043073)
0444043073Integrates pump, pressure sensor, heater, and temperature sensor. Verify fitment with engine serial number.
AdBlue Supply Module (Bosch Denoxtronic 2.2)
0444042019Fits some Deutz applications. Verify fitment with engine serial number.
Verify fitment with engine serial number.
Verify fitment with engine serial number.
- AdBlue Supply Module04604141
Verify fitment with engine serial number.
AdBlue Supply Module
04603859Verify fitment with engine serial number.
DEF Supply Module Assembly
1257797GTASSY,MODULE,SUPPLY,DEF,TCD3.6
DEF Supply Module Assembly
1257784GTGENIE 1257784GT MODULE SUPPLY DEF TCD 3.6
Get help to fix this fault by requesting a quote