928

Deutz-Fahr 928 – EMR4 ECU: Ad Blue Supply Module PWM Signal Period Outside Valid Range

Issue description

The engine control unit (ECU) has determined that the time period of the PWM signal from the AdBlue (DEF) supply module is outside its expected valid range. This specific PWM signal communicates the DEF temperature from the supply module to the ECU. The fault indicates a potential defect in the supply module's signal generation or a transmission issue within the wiring harness.

Applies to these machines

  • TCD 4.1
  • TCD 6.1
  • TCD 7.8

Check the cause

  1. Visually inspect the wiring harness and connectors between the AdBlue supply module and the engine control unit for chafing, corrosion on pins, moisture intrusion, or loose connections

  2. Check for other active or stored fault codes related to power supply, ground, or communication with other SCR system components that might trigger signal faults

  3. Verify DEF quality and condition, checking for contamination or crystallization

  4. Check the continuity and integrity of the PWM signal wire from the supply module connector to the ECU connector, looking for short circuits to power or ground

  5. Test the PWM signal directly from the supply module using a breakout harness and oscilloscope, or read the signal status using a Deutz-specific diagnostic tool like SerDia

Repair steps

  1. Address wiring issues

    If diagnostic checks reveal damaged wires or corroded connectors between the supply module and ECU, repair or replace the affected sections of the harness.

  2. Clear fault codes

    After completing any wiring repairs, clear all fault codes using a diagnostic scanner.

  3. Perform drive cycle

    Operate the machine to allow it to reach normal operating temperature so the SCR system can run its internal self-checks.

  4. Re-check for faults

    If the fault code 928 returns, and the wiring has been confirmed as good, the AdBlue supply module is the most likely cause of the failure.

  5. Replace AdBlue supply module

    If the module is determined to be faulty, it must be replaced. After replacement, it may be necessary to perform a system adaptation or reset using a diagnostic tool to ensure the new module is recognized by the ECU.

Parts you might need

(6)
  • AdBlue/DEF Supply Module

    04609002

    Verify correct part number using engine serial number

  • AdBlue/DEF Supply Module

    04603859

    Bosch for Deutz. Verify correct part number using engine serial number

  • AdBlue/DEF Supply Module

    0444043073

    Bosch for Deutz-Fahr. Verify correct part number using engine serial number

  • Fits Deutz 3.6, 4.1, 6.1 engines

  • Fits Deutz 3.6, 4.1, 6.1 engines

  • AdBlue/DEF Supply Module

    0444042019

    Bosch Denoxtronic 2.2, fits KHD-DEUTZ

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes