Fendt 0.0.11 – A002 - ECU, enhanced control: Data transfer A002 restricted to A051 / EDC / EMR bus fault

Data transfer failure or programming error between the enhanced control module and the electronic engine control unit (EDC/EMR). The tractor loses enhanced features (such as the forward/reverse indicator) and defaults to an emergency operating mode where it can only be driven using the mechanical foot throttle.

• 411 Vario COM III
• 412 Vario COM III
• 413 Vario COM III
• 414 Vario COM III
• 415 Vario COM III
• 712 Vario COM III
• 714 Vario COM III
• 716 Vario COM III
• 718 Vario COM III
• 818 Vario COM III
• 820 Vario COM III
• Farmer 409 Vario
• Farmer 410 Vario
• Farmer 411 Vario
• Farmer 412 Vario
• Farmer 413 Vario
• Farmer 414 Vario
• Farmer 415 Vario
• Favorit 711 Vario
• Favorit 712 Vario
• Favorit 714 Vario
• Favorit 715 Vario
• Favorit 716 Vario
• Favorit 717 Vario
• Favorit 718 Vario
• Favorit 724 Vario
• Favorit 725 Vario
• Favorit 726 Vario
• Favorit 727 Vario
• Favorit 729 Vario
• Favorit 731 Vario
• Favorit 815 Vario
• Favorit 817 Vario
• Favorit 818 Vario
• Favorit 820 Vario
• Favorit 916 Vario
• Favorit 920 Vario
• Favorit 924 Vario
• Favorit 926 Vario
• Favorit 930 Vario

1. 1

   Verify symptoms: confirm that the tractor can still be driven using the foot throttle, but the forward/reverse indicator on the display is missing or inoperative

2. 2

   Check the CAN bus wiring harness and connections between the A002 Enhanced Control ECU and the Engine Control Unit (EDC/EMR), referring to Wiring diagram Sheet 22 / 6 or Sheet 28

3. 3

   Connect the FENDIAS or SERDIA diagnostic tool to check for underlying programming errors in the ECU

1. 1

   Inspect and Repair Wiring

   Based on the wiring diagram (Sheet 22/6), test the CAN bus lines between the A002 and the engine control unit for continuity, shorts, or voltage drops. Repair any damaged wires or clean corroded connector pins.

2. 2

   EOL Reprogramming

   If the wiring is intact, EOL (End of Line) reprogramming is necessary. Use the FENDIAS diagnostic software to re-flash or reprogram the A002 ECU to correct the software fault.

3. 3

   Clear Codes

   Once reprogramming is complete, use the diagnostic tool to clear the 0.0.11 fault code from the system.

4. 4

   Module Replacement

   If the A002 ECU fails to accept the EOL programming or has suffered internal hardware failure, the module itself must be replaced and subsequently flash-programmed to match the tractor's chassis number.