Fendt 0.0.20 – A007 - Instrument cluster: CAN Bus fault between A007 instrument cluster and tractor electronics

CAN-Bus wiring or communication failure that results in a complete loss of display and leaves no tractor functions available. Typically caused by a loss of voltage supply to the CAN-Bus.

• 409 Vario
• 410 Vario
• 411 Vario
• 412 Vario
• 711 Vario
• 712 Vario
• 714 Vario
• 715 Vario
• 716 Vario
• 717 Vario
• 718 Vario
• 916 Vario
• 920 Vario
• 924 Vario
• 926 Vario
• 930 Vario
• 411 Vario COM III
• 412 Vario COM III
• 413 Vario COM III
• 414 Vario COM III
• 415 Vario COM III
• 712 Vario COM III
• 714 Vario COM III
• 716 Vario COM III
• 718 Vario COM III
• 818 Vario COM III
• 820 Vario COM III
• 309 Vario
• 310 Vario
• 311 Vario
• 312 Vario
• 815 Vario
• 817 Vario
• 818 Vario
• 933 Vario
• 936 Vario
• 939 Vario

1. 1

   Verify the voltage supply for the CAN-Bus located on the A013 printed circuit board (PCB / microfuse board)

2. 2

   Inspect microfuses F040 and F041 on the A013 board, which protect the CAN-Bus voltage supply

3. 3

   Check the wiring harness and separation points/connectors (such as the 68-pin X100 'blue' and X101 'yellow' connectors) between the A007 instrument panel and the central electrical system for corrosion, backed-out pins, or damage

1. 1

   Safely park the tractor and turn off the ignition.

2. 2

   Access the A013 fuse board (PCB).

3. 3

   Pull microfuses F040 and F041 and test them for continuity using a multimeter.

4. 4

   If either fuse is blown, replace it with a new fuse of the correct amperage and re-test the tractor's functions.

5. 5

   If the fuses are intact, use a multimeter to verify that voltage is actually reaching the A013 board and passing through the fuse terminals.

6. 6

   Trace the CAN-Bus wiring from the A013 board to the A007 instrument cluster.

   Repair any broken wires or clean any corroded connector pins (specifically at X100 and X101).

7. 7

   If the power supply, fuses, and wiring are all verified to be in good working order, replace the A007 instrument cluster.

   The cluster has likely suffered an internal failure.

8. 8

   Perform an EOL (End of Line) reprogramming procedure using FENDIAS diagnostic software.

   This is required if a new A007 VDO instrument panel is installed to configure the new cluster to the tractor and prevent fault code 0.1.50.