Fendt 1.2.83 – ECU EMR2: Reference voltage 1 for Y035 actuator out of allowed range

This fault indicates a voltage irregularity in the circuit for the Y035 EMR actuator. The reference voltage has fallen outside the permissible limits, prompting the system to use a substitute value of 5 VDC.

• 409 Vario
• 410 Vario
• 411 Vario
• 412 Vario
• 711 Vario
• 712 Vario
• 714 Vario
• 715 Vario
• 716 Vario
• 717 Vario
• 718 Vario
• 916 Vario
• 920 Vario
• 924 Vario
• 926 Vario
• 930 Vario
• Farmer 400 Vario
• Favorit 700 Vario
• Favorit 900 Vario
• Fendt 300 Vario series
• Fendt 400 Vario series
• Fendt 700 Vario series
• Fendt 800 Vario series
• Fendt 900 Vario series

1. 1

   Monitor the current to see if the error message disappears automatically, which indicates the current has returned to the normal range

2. 2

   Check the voltage supply directly to the ECU EMR2

3. 3

   Inspect the wiring harness running from the Y035 actuator to the ECU for shorts, breaks, or corrosion

4. 4

   Run Deutz SERDIA diagnostics to test the Y035 EMR actuator's feedback and control travel

1. 1

   Test voltage supply

   Test the voltage supply to the ECU EMR2 to ensure it is receiving proper power.

2. 2

   Inspect and repair wiring

   Inspect and repair any damaged wiring between the Y035 actuator and the ECU.

3. 3

   Cycle ignition

   Switch the tractor's ignition OFF, wait a moment, and then switch it back ON.

4. 4

   Replace ECU EMR2

   If the error code reappears after the power cycle and wiring checks, replace the ECU EMR2.