Fendt 4.1.47: Change of Operating Mode: Hitch Attached After Electrical Power Supply

The system has detected a change in operating mode where the hitch is attached after the electrical power supply has been activated. This may indicate an improper sequence of operations during machine setup or use.

1. 1

   Sequence of power activation and hitch attachment

2. 2

   Control system response to hitch attachment during power-on

3. 3

   User interface or operator input during mode change

1. 1

   Verify the sequence of operations

   Ensure that the hitch is attached before the electrical power supply is activated.

2. 2

   Check control system behavior

   Confirm that the control system properly handles the hitch attachment during power-on.

3. 3

   Review operator instructions

   Ensure that the operator follows the correct procedure for attaching the hitch and activating the power supply.