Fendt 5.1.8D – A002 - ECU, enhanced control: Checksum error old config data

Configuration data stored in the module's memory has a checksum mismatch, meaning the software parameters are corrupted, outdated, or were interrupted during a previous programming event. This causes limited enhanced control operation or reduced comfort.

• 409 Vario
• 410 Vario
• 411 Vario
• 412 Vario
• 711 Vario
• 712 Vario
• 714 Vario
• 715 Vario
• 716 Vario
• 717 Vario
• 718 Vario
• 916 Vario
• 920 Vario
• 924 Vario
• 926 Vario
• 930 Vario
• 411 Vario COM III
• 412 Vario COM III
• 413 Vario COM III
• 414 Vario COM III
• 415 Vario COM III
• 712 Vario COM III
• 714 Vario COM III
• 716 Vario COM III
• 718 Vario COM III
• 818 Vario COM III
• 820 Vario COM III
• 300 Vario (COM III)
• 400 Vario (COM III)
• 700 Vario (COM III)
• 800 Vario (COM III)
• 815 Vario
• 817 Vario
• 818 Vario
• 900 Vario (COM III)

1. 1

   Verify that the tractor is in a restricted operating mode and use the FENDIAS diagnostic tool to confirm 5.1.8D is the primary active code.

2. 2

   Check the power supply for the CAN bus on printed circuit board A013 (specifically fuses F040 and F041) to ensure no voltage drops or communication failures.

3. 3

   Look for accompanying code 5.1.8F (Checksum error old automatic function sequential data), which requires the same repair procedure.

1. 1

   Connect diagnostic tool

   Connect the Fendt FENDIAS diagnostic laptop/interface to the tractor's diagnostic port.

2. 2

   Establish communication

   Establish communication with the A002 - ECU, enhanced control.

3. 3

   Reprogram module

   Execute a new EOL (End-of-Line) programming procedure for the A002 module. This will overwrite the corrupted configuration data with a fresh, correct data record and recalculate the checksum.

4. 4

   Cycle ignition

   Once the EOL programming is complete, cycle the tractor's ignition.

5. 5

   Clear fault codes

   Clear the stored fault codes from the tractor's memory.

6. 6

   Perform functional test

   Perform a functional test of the tractor's enhanced control features (such as the Tractor Management System / TMS) to ensure the error does not return.