Fendt A.1.60 – A057 - ECU, steering controller (Auto-Guide): Fault only possible in calibration mode

A procedural error during the setup of the tractor's automated steering. It triggers when the Auto-Guide system is actively engaged and the calibration of the steering valve is started at the exact same time, or if a calibration sequence is restarted before the previous calibration attempt has completely finished.

• 411 Vario COM III
• 412 Vario COM III
• 413 Vario COM III
• 414 Vario COM III
• 415 Vario COM III
• 712 Vario COM III
• 714 Vario COM III
• 716 Vario COM III
• 718 Vario COM III
• 818 Vario COM III
• 820 Vario COM III
• Fendt 300 Vario (COM III)
• Fendt 400 Vario (COM III)
• Fendt 700 Vario (COM III)
• Fendt 800 Vario (COM III)
• Fendt 900 Vario (COM III)

1. 1

   Verify the current state of the Auto-Guide system on the terminal

2. 2

   Ensure the tractor is stationary and the steering wheel is not being manually turned

3. 3

   Ensure the Auto-Guide system is completely deactivated before attempting to calibrate the steering valve

1. 1

   Cancel or back out of the current calibration screen on the tractor's terminal.

2. 2

   Verify that the Auto-Guide system is turned off/inactive.

3. 3

   Allow any background calibration processes to time out or finish.

4. 4

   Restart the calibration procedure for the steering valve from the beginning.

5. 5

   Wait for the terminal to display "OK", which indicates a successful calibration.