A008

Fendt A008 – Enhanced Control ECU: Variotronic Terminal CAN Communication Failure

Issue description

This fault code indicates a communication failure on the CAN bus system, specifically a loss of communication or a terminal bus fault between the Variotronic terminal (A008) and the Enhanced Control ECU (A002). This failure disrupts the 'TeachIn' sequence programming, rendering the Variotronic TI automatic operation non-operational, and may log an error counter overflow.

Applies to these machines

  • Farmer 400 Vario
  • Favorit 700 Vario
  • Favorit 900 Vario
  • 300 to 930 Vario
  • 700 Vario (S4)
  • 800 Vario
  • 900 Vario (COM III)

Check the cause

  1. Restart the tractor by switching the ignition off and on to clear temporary communication glitches

  2. Inspect all fuses in main and secondary fuse boxes related to the terminal, control console, and sensor circuits

  3. Visually inspect wiring harnesses and connectors between the Vario terminal and ECU for physical damage, chafing, corrosion, or loose connections

  4. Perform a CAN bus resistance test with power off and battery disconnected (expect ~60 Ω between CAN-H and CAN-L at the terminal connector)

  5. Perform a CAN bus voltage test with power on (expect 2.5V-3.5V on CAN-H to ground, and 1.5V-2.5V on CAN-L to ground)

Repair steps

  1. Address physical faults

    Replace any blown fuses, repair damaged sections of the wiring harness, and clean or re-secure connectors. In some cases, issues have been resolved by replacing the main wiring harness.

  2. Isolate faulty component

    If wiring is intact but electrical tests fail, disconnect modules one by one while monitoring CAN bus resistance and voltage to identify the module causing the network fault.

  3. Perform EOL programming

    Use Fendt FenDias diagnostic software to perform End-of-Line (EOL) programming to re-establish communication between modules.

  4. Replace Vario terminal

    If the terminal is diagnosed with an internal failure (e.g., internal short, no communication despite good power/ground/CAN lines), replace the unit. EOL programming will be required after installation to integrate the new terminal.

Parts you might need

(5)
  • Vario Terminal / Display (10-inch)

    G835.970.010.080

    Verify correct part number by tractor model and serial number (COM2/COM3)

  • Vario Terminal / Display (10-inch)

    G835.970.010.078

    Verify correct part number by tractor model and serial number

  • Verify correct part number by tractor model and serial number

  • Vario Terminal / Display (Remanufactured)

    72487191

    Remanufactured part for COM2 and COM3 tractors (replaces G718970010137)

  • New part number, replaced by 72487191

Get help to fix this fault by requesting a quote

Browse other Fendt codes