D.1.07

Fendt D.1.07 – A101 - VarioDoc ECU or A055 - ECU: ISO BUS Error on Vario-Doc

Issue description

This fault code indicates an ISO BUS error on the Vario-Doc receiver buffer. It signifies a disruption in data transfer within the tractor's electronic communication system, specifically affecting data received by the VarioDoc system. This communication failure results in a faulty or incorrect display on the Vario terminal.

Applies to these machines

  • Fendt 400 Vario COM III
  • Fendt 700 Vario COM III
  • Fendt 800 Vario COM III
  • Fendt 700-900 SCR models

Check the cause

  1. Restart the tractor to clear temporary communication glitches and reset the data buffer

  2. Check the fault memory in the diagnostic menu for other related fault codes that could pinpoint the communication error

  3. Inspect wiring connected to the Vario terminal and ISO BUS system for visible damage, loose connections, or corrosion

  4. Verify if yearly terminal maintenance has been performed to free up storage memory and prevent general sluggishness

Repair steps

  1. Confirm the Fault

    Note the presence of the D.1.07 fault code on the terminal display.

  2. Restart System

    Shut down the tractor completely and wait for a few moments before restarting it. This action may clear the receiver buffer error.

  3. Inspect Connections

    If the error persists after a restart, perform a visual inspection of the ISO BUS and terminal wiring harnesses and connectors. Ensure all connections are secure and free of damage.

  4. Delete Fault Codes

    Manually delete the fault code from the tractor's memory via the terminal interface. If the fault does not reappear, the issue may have been temporary. If it returns immediately, further investigation is needed.

  5. Isolate the Issue

    If multiple implements or controllers are connected to the ISO BUS, disconnect them one by one to see if a faulty external device is causing the communication error on the bus.

  6. Terminal Replacement

    If the terminal itself is determined to be the source of the fault and cannot be repaired by addressing wiring or software issues, replacement may be necessary.

Parts you might need

(8)
  • Remanufactured Fendt Terminal

    72487191

    For Com2 and Com3 tractors. Replaces new part numbers G718970010137 or 72611391.

  • Replaced by 72487191.

  • Remanufactured Fendt Terminal (Replaced)

    72611391

    Replaced by 72487191.

  • Remanufactured Digital Terminal Display

    Z931970010087

    Confirm fitment by chassis number.

  • Vario Terminal Display

    G945.970.010.015

    Confirm fitment by chassis number.

  • Monitor Terminal 10.5"

    G842970010034

    Confirm fitment by chassis number.

  • Monitor Terminal 10.5"

    G842970010032

    Confirm fitment by chassis number.

  • Gen6 Terminal Panel

    H218PB256416A

    Confirm fitment by chassis number.

Get help to fix this fault by requesting a quote

Browse other Fendt codes