D.1.37

Fendt D.1.37 – A008 - Vario Terminal: Terminal Does Not Respond to Key Number Request

Issue description

The Vario terminal fails to respond to a request from another control unit for the number of buttons it has. This indicates a potential issue with the communication or functionality of the terminal, specifically an underlying communication failure on the CAN bus network. As a result, the terminal cannot communicate effectively with other modules, and system operation may not be possible.

Applies to these machines

  • Fendt 700 Vario Series
  • Fendt 800 Vario Series
  • Fendt 900 Vario Series
  • Fendt Farmer 400 Vario Series

Check the cause

  1. Restart the tractor by turning the ignition off and on again to see if the fault is temporary

  2. Use the terminal to call up all stored fault codes to check for other communication errors

  3. Inspect the power supply for the CAN bus, which is supplied via circuit board A013

  4. Check fuses F039 and F046 on the A013 fuse board (typically located behind a panel on the right side of the cab)

  5. Inspect the wiring harness and connectors (specifically the twisted pair of yellow and green wires) leading to the A008 Vario terminal for damage, corrosion, or loose connections

Repair steps

  1. Verify power at the terminal

    If the fuses are intact, test for power and ground directly at the terminal's electrical connector to ensure the wiring between the fuse board and the terminal is sound.

  2. Replace membrane keyboard

    If applicable (for 10-inch Vario terminals), a faulty keypad can cause communication issues. Loosen the terminal nuts, remove the casing, detach the holding iron, and swap the defective membrane keyboard for a new one.

  3. Repair or replace terminal

    If the internal electronics of the terminal have failed, send the unit to a professional third-party service for repair, or replace the entire A008 terminal unit.

Parts you might need

(4)
  • Vario Terminal (10-inch)

    G835.970.010.082

    OEM Fendt part. Alternate associated part numbers include G835.970.010.076, G835.970.010.074, and G842.970.010.026.

  • Membrane Keyboard for 10-inch Vario Terminal

    7100226006

    Ilgenfritz Mechatronics aftermarket replacement for terminals with a grey plastic frame.

  • Circuit BoardF260970160190

    Possible part number for Fendt circuit boards (including 72611285); direct application as A013 is unconfirmed.

  • Fuses F039 and F046

    Standard automotive fuses. Verify amperage rating from the fuse box diagram.

Get help to fix this fault by requesting a quote

Browse other Fendt codes