Iveco 9.4 – EDC (Electronic Diesel Control) / Engine ECU: Main Relay Anomaly
Issue description
The main contactor fails to disconnect after the ignition is turned off. This causes the control unit to stay supplied with power, which leaves the EDC indicator light on and eventually discharges the vehicle's battery.
Applies to these machines
6 machines- Iveco Daily
- Iveco Stralis
- Iveco Eurocargo
- Iveco Cursor 8 / 10 / 13 engines
- Astra HD8
- Iveco Motors / FPT Marine engines
Check the cause
Check the control unit supply wiring for any intermittent false contacts or shorts to battery voltage.
Check the wiring upstream from the main relay to find any break in the circuit.
Locate the main relay (often designated as T09) in the engine compartment fuse box and inspect the terminals and socket for corrosion, moisture, or signs of melting.
Check the associated EDC power fuses (such as F11, F16, F17, F18, and F22) to ensure none have blown due to a short circuit.
Repair steps
Disconnect Power
Disconnect the vehicle's battery to prevent further discharge and protect the EDC from electrical spikes during repair.
Access the Relay
Open the main engine compartment fuse box and locate the EDC Main Relay.
Test/Replace the Relay
Remove the main relay. Since the fault indicates the relay is stuck closed (failing to disconnect), swap it with a known good relay of the same amperage, or replace it with a new OEM relay.
Repair Wiring
If the relay socket or upstream wiring showed signs of damage or false contacts during your diagnostic checks, repair the wiring harness using proper testing lines and plug bushes. Never use improper means like wires or paperclips to bridge connections, as this can cause short circuits and damage the EDC.
Reconnect Power
Reconnect the vehicle's battery.
Clear the Fault Memory
Clear the failure memory using an IT2000 diagnostic tool, or manually via the Blink Code key. To clear manually: Turn the key change-over switch to the OFF position. Turn the key to the ON position and immediately keep the Blink Code diagnostic button pressed for 4 to 8 seconds. Wait and verify that the EDC warning light turns off and does not return to a steady glow.
Parts you might need
(5)- Main Relay / EDC Power Relay2991710
- Main Relay / EDC Power Relay4718222
Main Relay / EDC Power Relay
0041040442Main Relay / EDC Power Relay
1164018Main Relay / EDC Power Relay
0986AH0811
Get help to fix this fault by requesting a quote