P0002

JCB P0002 – ECM: Rail Pressure Negative Control Error During 'IMV-Only' Control

Issue description

The system is experiencing a positive control error in rail pressure during 'IMV-Only' control. The Engine Control Unit (ECU) PID controller is unable to stabilize the rail pressure control value using only the Inlet Metering Valve (IMV). This failure to maintain the desired fuel rail pressure can lead to the pressure being either too high or too low in the common rail system, which typically results in a significant reduction in engine power (torque reduction) or a complete engine shutdown.

Applies to these machines

  • Dieselmax
  • Ecomax Tier 4
  • Backhoe Loaders
  • Telescopic Handlers
  • Loadalls
  • Excavators

Check the cause

  1. Retrieve all fault codes to check for related fuel pressure sensor, fuel pump, or injector circuit faults

  2. Check fuel system integrity by ensuring sufficient fuel level, inspecting for low and high-pressure leaks, and replacing clogged fuel filters

  3. Visually inspect the wiring harness and connectors for the Inlet Metering Valve (IMV) and fuel rail pressure sensor for chafing, corrosion, bent pins, or loose connections

  4. Analyze live data using a scan tool to compare Commanded vs. Actual Fuel Rail Pressure and observe the IMV duty cycle

Repair steps

  1. Test IMV electrical circuit

    Disconnect the IMV connector and use a multimeter to check for proper voltage and ground from the ECM (Inlet Metering Valve Supply and Low Drive). Measure the IMV's internal resistance and compare to manufacturer specifications.

  2. Test fuel rail pressure sensor

    Back-probe the sensor's signal wire. With ignition on (engine off), voltage should be approximately 0.5V. At idle, it should read between 1.0V and 1.5V. Verify the 5V supply and ground are intact.

  3. Replace faulty components

    If the IMV fails electrical tests, replace it. If the fuel rail pressure sensor fails, replace the sensor (or the entire common rail assembly if required by the specific machine's service manual).

  4. Verify repair

    Clear fault codes from the ECM, start the engine, and monitor live data to ensure actual fuel rail pressure matches commanded pressure. Perform a load test to confirm the fault does not return.

Parts you might need

(4)
  • Delphi OEM equivalent: 9109-927

  • Rail Pressure Sensor

    320/06624A

    Alternate part numbers: 320/06624, 320/06624B, 320/06872, 320/06914. Delphi equivalents: 28389851, 28509144

  • Fuel Rail Assembly

    320/20855

    Example for Tier 4 engine. Replace complete assembly if required by specific model service manual.

  • Used on JCB Ecomax 4.4L and 4.8L Tier 4 engines.

Get help to fix this fault by requesting a quote

Browse other JCB codes