JCB P0004 – Engine ECU: IMV Driver Fault Detected
Issue description
A fault has been detected in the Inlet Metering Valve (IMV) driver circuit, indicating a 'circuit high' or 'open circuit' condition. This suggests an electrical issue within the circuit controlling the engine's fuel volume regulator, such as a short to battery or a disconnected wire. When this fault occurs, the Engine ECU forces the machine into a Reduced Power Mode (engine derate), significantly limiting engine torque to protect the system.
Applies to these machines
5 machines- JCB Telehandlers (e.g., 540-70)
- JCB Excavator Loaders
- JCB 412S Wheel Loader
- Machines with JCB 444 engines
- Machines with JCB EcoMAX Tier 4 engines
Check the cause
Visually inspect the wiring harness and connectors associated with the IMV on the high-pressure fuel pump for chafing, breaks, or corrosion.
Check the IMV electrical connector for loose pins, debris, or water ingress (often caused by pressure washing).
Ensure all machine and engine earth/ground connections are clean, tight, and free from damage.
With the ignition off, disconnect the IMV connector and check for continuity to ground on the power and signal wires.
With the ignition on (engine off), check for voltage at the IMV connector pins. A 'circuit high' fault (like sub-type P0004-12) suggests higher-than-expected voltage, potentially battery voltage, on the signal line.
Perform an 'IMV Override test' using a JCB-specific diagnostic tool (e.g., ServiceMaster) to test the valve's functionality.
Complete the testing procedure described in the 'Inlet metering valve' component page within the JCB EcoMAX Help Files.
Repair steps
Safety First
Stop the engine and allow it to cool completely before beginning any work on the fuel system. Disconnect the battery.
Locate the IMV
The Inlet Metering Valve is located on the high-pressure fuel injection pump.
Perform Diagnostic Checks
Complete the visual and electrical checks outlined above to confirm the fault is not due to wiring or connection issues.
Replace the Inlet Metering Valve
If the diagnostic checks confirm the valve itself is faulty, clean the area around the IMV thoroughly to prevent contamination. Disconnect the electrical connector, remove the screws or bolts securing the IMV to the high-pressure pump, and carefully remove the old valve along with any O-rings or seals. Install the new IMV with new seals, making sure it is seated correctly. Torque the retaining screws to the manufacturer's specification and reconnect the electrical connector.
Final Steps
Reconnect the battery. Clear the fault codes using a diagnostic tool. Start the engine and check for fuel leaks. Monitor the machine's performance and check if the P0004 fault code returns.
Parts you might need
(2)- Inlet Metering Valve (IMV)320/A6674
JCB OEM part number. Delphi part number: 28435244. Aftermarket cross-references: 9307515A, 9307Z515A, 9307-513A, 9307Z532A, 9109-927.
- High-Pressure Fuel Pump Assembly320/06620
Pump assembly that includes the IMV as a component.
Get help to fix this fault by requesting a quote