P0071-87

JCB P0071-87: Missing Ambient Air Temperature Message

Issue description

The system has detected a CAN bus message error indicating that the ambient environment temperature data from the Engine ECU is missing. This typically occurs because the Engine ECU is not receiving a valid signal from the Ambient Air Temperature (AAT) sensor due to a sensor failure or wiring issue. As a result, the ECU cannot broadcast this necessary temperature data to other control modules on the CAN network, which may affect functions like climate control or engine management.

Applies to these machines

  • Tracked Excavators
  • Wheeled Excavators
  • 525-60
  • JS200
  • JS140
  • JS205
  • EcoMAX Engine Models

Check the cause

  1. Record and clear the fault code using a diagnostic tool to see if P0071-87 returns immediately or under specific conditions

  2. Ensure the battery is healthy and all ground connections are clean and tight, as poor voltage can cause CAN bus errors

  3. Locate the Ambient Air Temperature (AAT) sensor (often near the front grille, behind the bumper, near a headlamp bracket, on a mirror arm, or on the rear of the machine) and ensure it is clear of dirt, ice, or debris

  4. Inspect the wiring harness leading to the AAT sensor for fraying, rubbing, melting, or cuts

  5. Unplug the sensor's electrical connector and check for corrosion (often green), bent pins, or a loose connection

Repair steps

  1. Test the AAT sensor

    Disconnect the AAT sensor and measure resistance across its terminals using a multimeter set to Ohms. Gently warm or cool the sensor; the resistance should change smoothly. An open circuit (infinite resistance) or short circuit (zero resistance) indicates a failed sensor.

  2. Test the wiring harness

    With the sensor disconnected and ignition off, perform a continuity test between the sensor connector and the Engine ECU. Check for open circuits, shorts to ground, and shorts to power (check for voltage at the signal wire with ignition on). Repair any damaged wires with sealed connectors.

  3. Verify ECU reference voltage

    If the sensor and wiring are good, check for a reference voltage being sent from the Engine ECU to the sensor. If missing, the ECU may require a software update or replacement.

  4. Replace sensor and clear codes

    If the AAT sensor is faulty, replace it with a new part. Clear all fault codes using a diagnostic scanner and operate the machine to confirm the fault does not return.

Parts you might need

(6)
  • JCB OEM part

  • Ambient Temp Sender

    716/C9471

    JCB OEM part

  • Temperature Sensor

    333/K3082

    Compatible with JS200, JS140, JS205

  • Aftermarket/Cross-Reference part

  • Aftermarket/Cross-Reference part

  • Ambient Air Temperature Sensor

    3907316M1

    Aftermarket/Cross-Reference part

Get help to fix this fault by requesting a quote

Browse other JCB codes