JCB P0105 – Engine ECU: MAP / Barometric Pressure Circuit Fault
Issue description
The Engine ECU has detected a malfunction in the electrical circuit of the Manifold Absolute Pressure (MAP) or Barometric Pressure (BARO) sensor, such as a missing or implausible signal. On JCB machines, this is typically associated with the T-MAP sensor, which measures both temperature and absolute pressure in the intake manifold. This fault affects the accurate measurement of system pressure, which is crucial for the control module to properly regulate the air-fuel mixture, ignition timing, and boost pressure.
Applies to these machines
4 machines- Generators & Lighting Towers
- Rough Terrain Fork Lifts
- Skid Steer Loaders (Robot)
- Wheeled Loaders
Check the cause
Visually inspect the MAP/T-MAP sensor's vacuum hose for cracks, blockages, or loose connections.
Inspect the sensor's electrical connector and wiring harness for frayed wires, corroded pins, or moisture intrusion.
Check for significant air intake leaks around the intake manifold gaskets or throttle body seals.
Use a scan tool to read live MAP sensor data: it should read close to barometric pressure with ignition on/engine off, 1 to 2 volts at idle, and increase proportionally as the engine is revved.
Test the sensor circuit (typically 3 or 4 wires: 5V ref, ground, signal, temp signal) with a multimeter: verify a steady 5-volt reference supply from the ECU with ignition on/engine off, check the ground wire for continuity to chassis/battery with minimal voltage drop, and ensure the signal wire voltage fluctuates with engine load while the engine is running.
Repair steps
Repair wiring and connections
If diagnostics reveal corrosion, loose pins, or damaged wires, repair or replace the affected sections of the wiring harness.
Fix vacuum and intake leaks
If vacuum leaks were found during inspection, replace any cracked hoses or faulty intake gaskets.
Clean the MAP/T-MAP sensor
Carefully remove the sensor and clean the port of any oil or carbon deposits that may be blocking the reading. Avoid using harsh chemicals.
Replace the MAP/T-MAP sensor
If the sensor provides no signal or a static signal despite good wiring and vacuum supply, replace it. Disconnect the electrical connector, remove the mounting bolt(s), remove the old sensor, install the new sensor ensuring seals or O-rings are correctly seated, secure the mounting bolt(s), and reconnect the electrical connector.
Clear codes and verify
Use a scan tool to clear the P0105 fault code from the ECU. Start the engine, monitor live data to ensure correct response to engine load, and perform a drive cycle to confirm the fix.
Parts you might need
(2)- Coated T-MAP Sensor320/B9534
Compatible with various JCB Generators, Forklifts, Skid Steers, and Loaders. Verify by serial number.
- T-MAP Sensor320/05558
Air boost pressure sensor with integrated air temperature sensor. Verify by serial number.
Get help to fix this fault by requesting a quote