P0254

JCB P0254 – PCM/ECM: High Signal 'A' in Fuel Metering Pump Circuit

Issue description

The engine control module (PCM/ECM) has detected an excessively high voltage signal (typically above 4.8V) from the primary fuel metering control circuit ('A'). This circuit regulates the amount of fuel entering the high-pressure fuel pump. A high signal disrupts the engine's ability to accurately calculate and deliver the precise amount of fuel needed, leading to severe performance and drivability issues.

Applies to these machines

  • 535-125

Check the cause

  1. Check for Technical Service Bulletins (TSBs) related to this fault code for the specific machine model

  2. Visually inspect the wiring harness and connectors associated with the fuel metering control valve (also known as the suction control valve or fuel quantity actuator) and fuel rail pressure (FRP) sensor for chafed or burnt insulation, corrosion, or loose connections

  3. Connect a diagnostic scan tool and monitor live data for 'Injection Pump Fuel Metering Control A' voltage to confirm it is above the specified limit (often over 5V)

  4. Use a digital multimeter (DVOM) to test the voltage and ground at the fuel metering control valve connector, specifically checking for a short to power in the signal wire

  5. Measure the resistance of the fuel lift pump

Repair steps

  1. Repair wiring and connectors

    If damage, corrosion, or loose connections are found during inspection, repair or replace the affected sections of the wiring harness or connectors. Clean corroded terminals and apply dielectric grease. Clear fault codes and retest.

  2. Test and replace fuel metering control valve

    If the wiring is in good condition, test the fuel metering control valve (also known as Fuel Control Actuator or Suction Control Valve) according to OEM specifications. Replace the valve if it is found to be defective.

  3. Inspect and replace fuel lift pump

    If fuel delivery issues persist (such as difficulty starting, power loss, or stalling), inspect the fuel lift pump for failure and replace it if necessary.

  4. Replace high-pressure fuel pump

    In some designs, the fuel metering control valve is integrated into the high-pressure fuel pump and cannot be serviced separately. If the valve is the point of failure in this setup, replace the entire high-pressure fuel pump assembly.

  5. Test and replace PCM/ECM

    As a last resort, if all wiring and components test good, suspect an internal driver circuit failure in the PCM/ECM causing a constant high voltage signal. Reprogram or replace the module after exhaustively ruling out all other causes.

Parts you might need

(12)
  • Fuel Metering Control Valve / Suction Control Valve (SCV) / Fuel Control Actuator

    Specific part number varies depending on engine and fuel system manufacturer (e.g., Delphi, Bosch).

  • Manual Fuel Lift Pump

    320/0701

    Used on some telehandlers and backhoe loaders.

  • Cross-reference OEM part number.

  • Manual Fuel Lift Pump

    320/07701A

    Cross-reference OEM part number.

  • Cross-reference OEM part number.

  • Manual Fuel Lift Pump

    32007201

    Cross-reference OEM part number.

  • Manual Fuel Lift Pump

    320072701A

    Cross-reference OEM part number.

  • Manual Fuel Lift Pump

    B53037

    Cross-reference OEM part number.

  • Manual Fuel Lift Pump

    301100041

    Cross-reference OEM part number.

  • Manual Fuel Lift Pump

    54889

    Cross-reference OEM part number.

  • High-Pressure Fuel Pump

    Replacement necessary if the metering valve is integral and has failed. Part numbers are specific to the engine model.

  • Powertrain Control Module (PCM/ECM)

    Last-resort replacement. Must be matched to the machine's VIN and programmed accordingly.

Get help to fix this fault by requesting a quote

Browse other JCB codes