JCB P02A7: Injector 0 MDP Trim Exceeds Maximum Calibrated Threshold

The fault is triggered when the MDP trim of Injector 0 exceeds the maximum calibrated threshold. This condition is detected at low rail pressure and may indicate an issue with the injector's performance or calibration.

1. 1

   Injector 0

2. 2

   Rail pressure sensor

3. 3

   Injector control circuit

1. 1

   Inspect

   Inspect Injector 0 for signs of damage, wear, or improper installation.

2. 2

   Test

   Test the rail pressure sensor to ensure it is providing accurate readings at low pressure.

3. 3

   Check

   Check the control circuit for Injector 0 for continuity, proper connections, and signs of damage.