P060E

JCB P060E – ECU: Functional Safety Fault

Issue description

A functional safety fault has been detected in the system, specifically an internal processing failure during the ECU's self-check of the throttle position monitoring system. This fault relates to the integrity and performance of the ECU's internal circuitry and its ability to reliably process throttle command data. It is typically rated as a critical safety fault that can trigger an engine stop or torque reduction command from the ECU to prevent unsafe operation.

Applies to these machines

  • JCB T4i / T4F Engines
  • JCB Ecomax Tier 4 Engines
  • JCB Stage-V Electronic Engines
  • Tracked & Wheeled Excavators
  • TM320 Wheeled Loader

Check the cause

  1. Record and clear the code using a diagnostic tool like JCB ServiceMaster to observe if it returns immediately under load, ruling out intermittent 'ghost' codes caused by temporary electrical issues

  2. Check the ECU software version to ensure it is up to date, as outdated software can cause erroneous fault codes

  3. Visually inspect the wiring harness connected to the Engine ECU for chafing, melting, or cuts

  4. Unplug the ECU connectors and check for corrosion (often green), bent pins, or contamination from moisture or oil, ensuring all connectors are securely latched

  5. Verify power and ground circuits by checking battery voltage stability and inspecting main electrical earth points on the engine and machine for cleanliness and tightness

Repair steps

  1. Re-flash ECU software

    Connect a laptop with JCB ServiceMaster to the machine's CANbus diagnostic port. Turn the ignition ON but DO NOT start the engine. Use the 'Flashloader' tool to select the correct data file for the machine's model and serial number, and initiate reprogramming. Do not interrupt this process.

  2. Perform post-flash procedures

    After the flash is complete, turn the ignition OFF, disconnect the diagnostic tool, and let the machine's modules go to sleep. Reconnect the tool, clear any stored DTCs, and perform necessary relearn procedures (e.g., for fuel injectors).

  3. Order replacement ECU

    If the software re-flash does not resolve the fault, or if internal hardware failure is confirmed, identify the correct replacement ECU part number using the machine's serial number in the JCB Service Parts Plus+ (SPP+) system.

  4. Replace ECU hardware

    Disconnect the battery to isolate power. Rotate the locking levers on the harness connectors to unplug them, unbolt the old ECU from its bracket, mount the new ECU, and securely reconnect the harness.

  5. Program new ECU

    Use JCB ServiceMaster to program the blank ECU. Restore defaults, flash the correct software file, and program injector calibration codes before the ECU will accept the main flash file.

Parts you might need

(4)
  • Example replacement for 320/09705 on a T4 engine. Must verify exact part via JCB SPP+ using machine serial number.

  • Engine Control Module (ECU)

    320/D9637N

    Example for 55kW JCB Stage V 430 engine. Must verify exact part via JCB SPP+ using machine serial number.

  • Engine Control Module (ECU)

    320/09746N

    Example for JCB Tier 4i 81kW engine. Must verify exact part via JCB SPP+ using machine serial number.

  • Example for 93kw T4i engine (OEM service replacement). Must verify exact part via JCB SPP+ using machine serial number.

Get help to fix this fault by requesting a quote

Browse other JCB codes