JCB P1063 – ECU: PCV 2 Feedback Fault
Issue description
The Engine Control Unit (ECU) has detected an issue with the feedback signal from Pressure Control Valve 2 (PCV 2), which typically refers to the Inlet Metering Valve (IMV) on the high-pressure fuel pump. This indicates a discrepancy between the signal the ECU expects to receive and the actual signal, pointing to an electrical or functional problem with the valve or its monitoring circuit that prevents the ECU from verifying the valve's status and correctly regulating fuel pressure.
Applies to these machines
8 machines- Tracked Excavators
- JS200
- JS210
- JS220
- Wheeled Excavators
- Large Wheeled Loading Shovels (with JCB444 engines)
- Machines with JCB Dieselmax Tier 4 engines
- Machines with JCB EcoMax Tier 4 engines
Check the cause
Record and clear the code using a diagnostic tool to observe if it returns immediately or under specific operating conditions (e.g., under load)
Inspect the wiring harness connected to the fuel pressure control valves on the high-pressure pump and fuel rail for rubbing, chafing, melting, or physical damage
Disconnect and inspect the electrical connectors for both the Inlet Metering Valve and the rail pressure sensor/regulator for corrosion, bent pins, or moisture intrusion
Inspect the fuel system for leaks in the high-pressure lines, injectors, fuel rail, and high-pressure pump, and ensure fuel filters are not blocked
Verify battery voltage is stable and within specification (at least 12.4V for a 12V system) and ensure all engine and chassis ground straps are clean and tight
Use a multimeter to perform electrical checks on the suspect valve and its circuit, checking for correct resistance across terminals and verifying voltage and signal integrity
Repair steps
Isolate the faulty component
Based on the diagnostic checks, determine if the fault lies with the valve itself, the wiring, or the ECU. A feedback fault often points towards an internal failure of the component's sensor or a wiring issue.
Repair wiring and connectors
If the wiring harness or connectors are found to be damaged, repair or replace them as necessary. Ensure all connections are clean and secure.
Replace Inlet Metering Valve (IMV)
If the valve is determined to be faulty, thoroughly clean the area around the high-pressure fuel pump before removal. Disconnect the electrical connector, remove retaining bolts, and extract the old valve. Install the new valve ensuring seals or O-rings are correctly seated, torque bolts to manufacturer specification, and reconnect.
Perform system test
Clear all fault codes from the ECU. Start the engine and let it run while monitoring live data with a diagnostic tool to ensure fuel rail pressure is being controlled correctly and P1063 does not reappear.
Parts you might need
(2)Inlet Metering Valve (IMV)
9307Z532AAlso known as Fuel Pressure Control Valve. Verify correct part number using machine serial number.
- Inlet Metering Valve (IMV)9109-927
Alternate part number listed for JCB applications. Verify correct part number using machine serial number.
Get help to fix this fault by requesting a quote