P208B-02

JCB P208B-02 – Aftertreatment System ECU: Supply Module Pump Speed Permanent Deviation

Issue description

The system has detected a permanent deviation in the speed of the DEF supply module pump. The pump's actual rotational speed is consistently different from the speed commanded by the control unit, indicating an ongoing issue rather than a temporary glitch. This is often caused by an error on the PWM (Pulse Width Modulation) output powerstage for the supply module actuator. When active, the system enters a Reduced Power Mode (Engine Derate) to limit emissions and protect aftertreatment components.

Applies to these machines

  • Tier 4 Final (T4F) JCB EcoMax engines
  • JS Excavator SMART Controls

Check the cause

  1. Stop the engine and allow it to cool before beginning diagnostic work

  2. Inspect the DEF supply module wiring harness for chafing, melting, or improper routing

  3. Disconnect the supply module connector and check terminals for corrosion (often green), moisture, debris, or bent/unsecured pins (poor sealing or damage from pressure washing can be a cause)

  4. Check machine ground points for damaged or loose earth connections

  5. Verify DEF tank level is not empty and fluid is not contaminated (which can introduce air or damage the pump)

  6. Check for related active fault codes, such as P204F (blocked DEF filter) or P208A-13 (open circuits on pump motor)

  7. Use JCB ServiceMaster to perform a 'DEF pump test' to check electrical supply and harness continuity

  8. Inspect the DEF filter within the supply module for blockages

Repair steps

  1. Depressurize and drain

    Safely depressurize the DEF system. Drain the DEF tank if necessary to prevent spillage.

  2. Disconnect lines and harness

    Disconnect the electrical harness connector from the supply module. Disconnect the heated DEF lines (suction, pressure, and backflow), being prepared to contain residual fluid.

  3. Remove supply module

    Unbolt the faulty DEF supply module from its mounting bracket.

  4. Install new module

    Mount the replacement DEF supply module to the bracket.

  5. Reconnect connections

    Reconnect the heated DEF lines and the electrical harness connector, ensuring all connections are secure and properly sealed.

  6. Refill and prime system

    Refill the DEF tank with clean, specified fluid. Initiate the priming procedure via the JCB ServiceMaster tool. Start the machine and allow up to five minutes for the SCR system to prime and run internal diagnostics to clear the fault.

Parts you might need

(3)
  • Verify correct part number (320/A9100 or 400/W3319) using machine serial number. Often manufactured by Bosch.

  • DEF Supply Module

    400/W3319

    Alternate part number. Verify correct part number using machine serial number.

  • Filter element located inside the supply module; includes compensation element and removal tool.

Get help to fix this fault by requesting a quote

Browse other JCB codes