P2200-63

JCB P2200-63 – Aftertreatment System ECU: Upstream NOx Sensor Self Diagnostic Timeout

Issue description

The system has detected a timeout during the self-diagnostic process of the upstream NOx sensor. This indicates that the sensor's internal diagnostic check did not finish within the expected time frame, resulting in a circuit/component protection time-out. This condition can lead to a reduction in engine power as the machine enters a derated or limp-home mode.

Applies to these machines

  • Tier 4 engines
  • EcoMAX
  • Tracked Excavators
  • Wheeled Excavators
  • Wheel Loaders
  • 406 SV
  • 407 SV
  • 409 SV
  • Kohler engines

Check the cause

  1. Allow the engine and exhaust system to cool down completely before starting any diagnostic work

  2. Inspect the NOx sensor's wiring harness for chafing or incorrect routing

  3. Check the electrical connector for damage, loose pins, corrosion, or water/debris ingress (often caused by pressure washing)

  4. Check the power supply and relay (the upstream NOx sensor, downstream NOx sensor, and AdBlue/DEF tank often share the same power source)

  5. Verify the correct voltage sensor is installed for the machine (e.g., a 12-volt sensor on a 12-volt machine)

  6. Scan for other active or stored fault codes, as issues with other aftertreatment components can trigger NOx sensor faults

  7. Inspect the exhaust system for any leaks upstream of the sensor, which can cause erratic readings

Repair steps

  1. Stop engine and cool down

    Ensure the engine is turned off and the exhaust system has had sufficient time to cool down.

  2. Disconnect sensor

    Disconnect the electrical connector from the NOx sensor control unit.

  3. Remove sensor

    Carefully unscrew the NOx sensor probe from the exhaust pipe.

  4. Install new sensor

    Apply a small amount of anti-seize compound to the threads of the new sensor (do not get any on the sensor tip). Screw the new sensor into the exhaust pipe, tighten to the manufacturer's specified torque, and reconnect the electrical harness.

  5. Clear fault codes

    Use a diagnostic tool to clear the P2200-63 fault code from the Aftertreatment System ECU.

  6. Perform data reset or regeneration

    If required by the specific machine system, use the diagnostic tool to perform a NOx sensor data reset or a manual DPF regeneration cycle to ensure the system recognizes the new sensor.

Parts you might need

(1)
  • Upstream NOx Sensor

    Also referred to as Inlet NOx Sensor or NOx Sensor 1. Includes both the exhaust probe and the sensor control unit (SCU). Must match the exact OEM part number; brands are not interchangeable.

Get help to fix this fault by requesting a quote

Browse other JCB codes