P2201-17

JCB P2201-17 – Aftertreatment System ECU: Downstream NOx Offset Max Error Detection

Issue description

The Aftertreatment System ECU has detected that the downstream NOx sensor is reporting a signal above the acceptable threshold (offset max error). This indicates the sensor's baseline reading or measurement is higher than the system is calibrated to accept. This condition leads to inaccurate measurements of NOx levels after the exhaust gas passes through the Selective Catalytic Reduction (SCR) system, preventing the ECU from properly regulating Diesel Exhaust Fluid (DEF) injection or monitoring aftertreatment efficiency.

Applies to these machines

  • Machines with JCB EcoMAX engines (Tier 4 Final / Stage V)
  • Machines with Kohler KDI engines (Tier 4 Final / Stage V)
  • Backhoe loaders (mid-2010s onward)
  • Telehandlers (mid-2010s onward)
  • Excavators (mid-2010s onward)

Check the cause

  1. Scan the system for any other active or stored fault codes (faults related to the NOx sensor heater or power supply can provide diagnostic clues)

  2. Inspect the downstream NOx sensor wiring harness and connectors for chafing, melting, corrosion, bent/loose pins, or water/debris ingress

  3. Verify power supply and machine ground connections (the downstream NOx sensor shares a power source and relay with the upstream sensor and DEF tank), and confirm that the correct voltage sensor is installed (e.g., a 12-volt sensor on a 12-volt machine)

  4. Check the exhaust system for leaks upstream of the downstream NOx sensor, which can introduce oxygen and skew readings

  5. Ensure Diesel Exhaust Fluid (DEF) is not contaminated and is at the correct concentration (typically 32.5% urea)

Repair steps

  1. Prepare machine for service

    Park the machine on level ground, stop the engine, and allow the exhaust system to completely cool to prevent burns. Disconnect the battery.

  2. Remove the faulty sensor

    Locate the downstream NOx sensor in the exhaust system after the SCR catalyst. Disconnect the electrical connector from the control module and unclip the wiring harness. Use a specialized NOx sensor socket or wrench to unscrew the probe. Apply penetrating oil if seized.

  3. Prepare exhaust bung

    Clean the threads in the exhaust pipe bung to ensure a good seal for the new sensor.

  4. Install the new sensor

    Lightly apply a suitable anti-seize compound to the new sensor's threads, ensuring none gets on the sensor tip. Screw the sensor in by hand to avoid cross-threading, then tighten to 40-60 Nm.

  5. Route and connect wiring

    Mount the new sensor's control module and connect the electrical plug. Route the wiring harness along its original path, securing it clear of hot or moving parts.

  6. Clear codes and recalibrate

    Reconnect the battery. Use a diagnostic tool to clear all aftertreatment fault codes. Perform a drive cycle or run the machine under load as specified by the manufacturer to allow the ECU to recognize and recalibrate the new sensor.

Parts you might need

(6)
  • Engine NOx sensor - downstream

    400/J4546

    Verify compatibility with machine serial number

  • NOx Sensor

    400/14470

    Verify compatibility with machine serial number

  • Verify compatibility with machine serial number

  • Cross-referenced with Bosch part 0281006533 / 0281006534

  • NOx Sensor (Continental alternative)

    335/A2190

    Cross-referenced with Continental part

  • Nox Sensor 2-3 Downstream

    10901016902

    For Kohler engines

Get help to fix this fault by requesting a quote

Browse other JCB codes