JCB P2227-00 – ECM: Baro Sensor Fault
Issue description
The Engine Control Module (ECM) has detected that the barometric pressure sensor's signal is outside the expected range or is not correlating correctly with other sensor readings, such as the manifold absolute pressure (MAP) sensor. The barometric pressure sensor measures atmospheric pressure to allow the ECM to adjust the air-fuel mixture and ignition timing for changes in altitude and air density. An incorrect signal can lead to poor engine performance, increased emissions, reduced fuel efficiency, and may trigger a reduction in engine torque as a protective measure.
Applies to these machines
23 machines- JS115
- JS130
- JS145
- JS160
- JS175
- JS180
- JS190
- JS200
- JS210
- JS220
- JS235
- JS240
- JS260
- JS290
- JS300
- JS330
- JS360
- JZ140
- JZ235
- JZ255
- 808X
- 536
- Wheelie Models
Check the cause
Visually inspect the barometric pressure sensor (often located in the intake manifold area or on the engine block) for physical damage or fluid contamination.
Examine the sensor's electrical connector for corrosion, bent pins, or a loose connection.
Trace the wiring harness connected to the sensor, looking for signs of fraying, chafing, heat damage, or rodent damage.
Connect a scan tool with the ignition on and engine off, and compare the live barometric pressure sensor reading to the actual local atmospheric pressure (approximately 14.7 psi / 101 kPa at sea level).
With the engine off, verify that the barometric pressure reading is nearly identical to the manifold absolute pressure (MAP) sensor reading.
Perform a voltage test at the sensor connector with the ignition on to verify a 5-volt reference from the ECM and a signal voltage between 0.5 and 4.5 volts (0V or a constant 5V indicates a fault).
Disconnect the sensor and perform a circuit integrity test, checking for continuity and resistance in the power, ground, and signal wires between the sensor connector and the ECM.
Repair steps
Repair wiring and connectors
If diagnostic checks reveal wiring issues, clean any corrosion from the connector pins using electrical contact cleaner. Repair frayed or broken wires using appropriate splicing techniques and heat-shrink tubing. Ensure the connector is securely fastened.
Replace the barometric pressure sensor
If the wiring tests fine but the sensor is faulty, disconnect the battery, unplug the electrical connector, and unbolt the old sensor. Install the new sensor, tighten mounting bolts to manufacturer specifications (do not over-tighten), and reconnect the connector and battery.
Update ECM software
Check for any available ECM software updates from JCB. Outdated ECM software can sometimes misinterpret sensor data, leading to a false P2227 code.
Clear codes and verify repair
After completing repairs or updates, clear the diagnostic trouble codes using a scan tool. Start the machine and let it run to confirm that the Check Engine light does not reappear and the fault code does not return.
Parts you might need
(1)OEM JCB part. Fits various JS Tracked/Wheeled Excavators and Telescopic Handlers. Aftermarket versions also available.
Get help to fix this fault by requesting a quote