P2413-86

JCB P2413-86 – Engine ECU: CAN Bus Message Error from Engine ECU

Issue description

A communication breakdown has occurred on the CAN bus network regarding messages originating from the Engine ECU. While the code indicates a communication error, it is frequently triggered by underlying performance issues within the Exhaust Gas Recirculation (EGR) system. The Engine ECU monitors the EGR system and logs this CAN error if the expected response is not received.

Applies to these machines

  • EcoMAX Tier 4
  • Tier 4 JCB loaders
  • Tier 4i EcoMax
  • T4 Final EcoMax
  • JS115
  • JS130
  • JS145W
  • JS180

Check the cause

  1. Record and clear the code using a diagnostic tool to see if it returns immediately, ruling out temporary electrical surges.

  2. Check for other active fault codes, particularly EGR-related codes like P0400, which can indicate the root cause.

  3. Inspect battery voltage and ground connections, ensuring all ground straps are clean, tight, and free of corrosion.

  4. Visually inspect wiring harnesses connected to the Engine ECU and EGR system for rubbing, fraying, or heat damage.

  5. Examine the large multi-plug connector on top of the engine for water ingress or pushed-back pins, and disconnect EGR/ECU connectors (with the ignition off) to check for corrosion or bent pins.

  6. Remove and inspect the TMAP sensor for heavy carbon coating, which indicates a clogged EGR cooler and passages.

  7. Inspect the EGR valve to ensure it is not stuck open or closed due to carbon deposits and verify it can move mechanically.

  8. Check the EGR cooler for leaks, looking for a wet mixer tube in the inlet manifold.

Repair steps

  1. Repair wiring and connectors

    Repair or replace any damaged wiring or corroded connectors. Ensure all connections are clean and secure. For the main engine multi-plug, repair individual pins or replace the connector housing as needed.

  2. Clean EGR system

    Thoroughly clean carbon buildup from the TMAP sensor, EGR valve, EGR cooler, and associated pipework and passages. Remove and clean the intake manifold if necessary.

  3. Replace EGR valve or sensors

    If the EGR valve remains mechanically stuck, electrically faulty, or does not function correctly after cleaning, replace it. Replace the TMAP or EGR temperature sensor if diagnostic checks prove them faulty.

  4. Update or replace Engine ECU

    If all other components and wiring are verified good, check for available JCB software updates. As a last resort, replace the Engine ECU.

  5. Verify repair

    Clear all fault codes using a diagnostic tool. Start the engine and operate the machine under load to ensure the P2413-86 code does not return.

Parts you might need

(6)
  • EGR Valve

    320/06174

    General part number, verify compatibility with serial number

  • EGR Valve Kit

    320/D9110

    OEM JCB EGR Valve Kit

  • EGR Valve (Aftermarket)

    02/802624

    Aftermarket option for JS115, JS130, JS145W, JS180

  • TMAP Sensor

    Temperature and Manifold Absolute Pressure Sensor

  • Engine ECU

    Engine Control Unit, verify software updates before replacement

  • Engine wiring harness / multi-plug

    Replace housing or pins if damaged

Get help to fix this fault by requesting a quote

Browse other JCB codes