P2413-87

JCB P2413-87 – Engine ECU: Impeded EGR Fault Data or Bus Off for EGR Faults from Engine ECU

Issue description

The Engine ECU has detected a loss of communication or invalid data from the Exhaust Gas Recirculation (EGR) system over the CAN bus network. Specifically, expected data packets are missing or corrupted, preventing the ECU from properly monitoring or controlling the EGR valve. This communication disruption typically triggers an engine power derate.

Applies to these machines

  • JS115
  • JS130
  • JS145
  • JS200
  • JS205
  • JS220
  • 3CX
  • 4CX
  • 531-70
  • TM320
  • 100C-2

Check the cause

  1. Check for additional active or stored fault codes using a diagnostic tool (especially related to VGT turbo, intake throttle, or temperature sensors)

  2. Verify the Engine ECU software is up to date

  3. Inspect the main engine harness and EGR valve harness for chafing, rubbing, or heat damage

  4. Examine the multi-plug connector on top of the engine for water ingress and pushed-back pins

  5. Disconnect and inspect the EGR valve and ECU connectors for corrosion, debris, or moisture

  6. Verify all machine and engine ground connections are clean, tight, and free from corrosion

  7. Inspect the TMAP sensor for heavy carbon coating, which indicates a blocked EGR cooler

  8. Check the EGR valve for mechanical seizing or sticking, and test its movement using a diagnostic tool to command it open and closed

  9. Inspect the EGR cooler for blockages or leaks

Repair steps

  1. Connect Diagnostic Tool

    Connect a suitable diagnostic tool (e.g., JCB ServiceMaster) to the machine to read and record all fault codes. Do not clear them immediately.

  2. Address other faults

    If other fault codes are present (e.g., VGT turbo, intake throttle), diagnose and repair them first, as they may be the root cause of the EGR communication error.

  3. Perform electrical inspection

    Check continuity and resistance on the CAN bus wires between the EGR valve and the Engine ECU. Repair or replace the harness if damaged. Inspect the engine top multi-plug for pushed-back pins or water damage.

  4. Test EGR valve and cooler

    If electrical checks pass, remove and inspect the TMAP sensor for carbon buildup. Remove the EGR valve to ensure it moves freely. If a restriction is suspected, remove the EGR cooler and attempt to pass air through it.

  5. Replace faulty components

    Repair or replace the wiring harness if damaged. Replace the EGR valve if it is seized or fails functional tests. Replace the EGR cooler if it is blocked. Always replace the EGR cooler seals if the cooler is removed.

  6. Final verification and calibration

    Clear all fault codes using JCB ServiceMaster. Start the engine and run through various RPM ranges to confirm the fault does not return. Perform an EGR valve learn or calibration procedure if the valve was replaced.

Parts you might need

(5)
  • For T3/T4 engines, including 444 EcoMAX in 3CX, 4CX, Loadall, JS205, JS220

  • EGR Valve Assembly

    333/H5711

    For 2019 JCB 100C-2 with T4F engine

  • EGR Valve Assembly

    320/06174

    General JCB EGR Valve

  • Referenced for 2019 JCB 100C-2

  • Required each time the cooler is removed

Get help to fix this fault by requesting a quote

Browse other JCB codes