JCB P242B-16 – ECM: Catalyst Temperature Sensor Plausibility Error Below Minimum Threshold
Issue description
The Engine Control Module (ECM) has detected that the voltage signal from a specific exhaust gas temperature (EGT) sensor is below the minimum expected value for the current operating conditions. This plausibility error indicates that the measured temperature is illogically low compared to other sensor readings or the ECM's internal temperature model, pointing to a fault in the sensor, its associated circuitry, or an exhaust leak.
Applies to these machines
13 machines- Tier 4 Final (T4F) engines
- EcoMax
- tracked excavators
- wheeled loaders
- telehandlers
- generators
- 411
- 413
- 417
- 419
- TM320
- wheeled excavators
- JS Excavators
Check the cause
Inspect the EGT sensor wiring harness for heat damage, melted or brittle insulation, broken wires, and chafing near hot exhaust components.
Disconnect the EGT sensor electrical connector and examine pins for corrosion, moisture ingress, or a loose fit.
Use a diagnostic scan tool to monitor live data from all EGT sensors. Compare readings during a cold start and warm-up to identify if the suspect sensor is reading significantly lower than others.
Inspect the exhaust system for leaks upstream of or near the temperature sensor, which can draw in cooler ambient air and skew readings.
Remove the sensor and inspect its tip for heavy soot or particulate matter buildup, which may indicate a compromised sensor or deeper aftertreatment issues.
Repair steps
Isolate the faulty sensor
Based on diagnostic live data, confirm which EGT sensor is causing the fault. This code often refers to Bank 1, Sensor 3, typically located in or after the DPF or SCR catalyst. Refer to the machine's service manual for exact location.
Repair wiring or connectors
If harness or connector damage was found, repair it. Ensure all connections are clean, secure, and properly routed away from high-heat sources. Clear codes and re-test.
Replace the EGT sensor
Disconnect the negative battery terminal. Disconnect the sensor's electrical connector and unscrew the old sensor from the exhaust pipe (use penetrating oil if necessary). Apply a small amount of anti-seize compound to the threads of the new sensor (avoiding the tip), install, and tighten to OEM torque specifications.
Clear codes and verify repair
Reconnect the battery and use a diagnostic tool to clear the P242B-16 fault code. Start the engine, monitor live data from the new sensor for plausibility, and perform a full warm-up cycle or road test to confirm the fault does not return.
Parts you might need
(4)- Exhaust Gas Temperature Sensor320/A9184
Genuine JCB exhaust temperature sensor for Tier 4 machinery with SCR systems (generators, tracked/wheeled excavators).
- Turbo Temperature Sensor320/06233
Genuine JCB turbo temperature sensor for Tier 4 machinery (411, 413, 417, 419, TM320).
- Temperature Sensor716/30111
Temperature sensor for JCB 444 engines in various JS excavator models.
Coolant Temperature Sensor
320/04545Sometimes cross-referenced in searches; verify application before ordering.
Get help to fix this fault by requesting a quote