JCB P2456 – ECM: Differential Pressure Sensor Zero Position Learning Fault
Issue description
The Engine Control Module (ECM) has detected a failure in the zero position learning process of the Diesel Particulate Filter (DPF) differential pressure sensor. The sensor is not properly calibrating to its reference baseline position, which prevents the ECM from accurately measuring soot accumulation. This disrupts the DPF regeneration process and typically forces the machine into a low power mode to prevent system damage.
Applies to these machines
3 machines- JCB Tracked & Wheeled Excavators (JS Series)
- Machines using Isuzu Tier 4i engines
- JCB Telehandlers (Loadall)
Check the cause
Inspect the two hoses connected to the DPF differential pressure sensor for cracks, blockages, kinks, heat damage, and secure attachment
Examine the sensor's electrical harness and connector pins for frayed wires, heat damage, corrosion, or a loose fit
Disconnect the sensor hoses and gently blow compressed air through them to ensure they are clear of soot or debris
Connect a diagnostic tool to monitor live data; with the engine off, the pressure should read at or near zero. A significant reading confirms a zero-offset issue
Observe the sensor's voltage readings with the engine running to ensure a stable signal that changes with RPM and load
Repair steps
Address preliminary faults
Repair or replace any blocked hoses, damaged wiring, or loose connectors found during inspection. Clear fault codes and operate the machine to see if the fault returns.
Replace DPF pressure sensor
If the sensor provides an incorrect zero reading or erratic data despite good wiring and clear hoses, disconnect the negative battery terminal, remove the old sensor from the chassis near the DPF, and install the new sensor ensuring hoses and connectors match.
Perform sensor calibration
Using a diagnostic tool like JCB Servicemaster, navigate to the engine service functions and select 'Differential Pressure Sensor Learning' or 'Reset Adaptive Settings'. Follow on-screen prompts with ignition on, engine off, and battery above 12V to record the new baseline.
Verify repair
Clear all fault codes, start the engine, and operate the machine under load. Perform a forced DPF regeneration using the diagnostic tool to verify the system is functioning correctly.
Parts you might need
(2)DPF Differential Pressure Sensor
400/02521Verify correct part number for specific machine model and serial number using an official JCB parts catalog.
- Exhaust Manifold Pressure Sensor320/06194
Alternative part number; verify fitment via official JCB parts catalog.
Get help to fix this fault by requesting a quote