P2502-87

JCB P2502-87 – Vehicle Control Unit: Missing Engine ECU Power Management Message

Issue description

A communication failure has occurred on the CAN bus where the main vehicle control unit (or similar primary controller) has not received expected power management status messages from the Engine ECU. This indicates a communication issue that may affect the proper functioning of the power management system. This is a communication-based fault, not a physical fault with the charging system's voltage itself.

Applies to these machines

  • JS Series excavators
  • Crawler excavators
  • Wheeled excavators

Check the cause

  1. Ensure the machine's battery is fully charged, as low voltage can trigger various CAN bus communication errors

  2. Inspect all ground strap connections to ensure they are clean and tight

  3. Visually inspect the wiring harnesses and connectors between the Engine ECU and other control modules for chafing, corrosion, or loose connections, paying close attention to routing around pivot points

  4. Perform a CAN Bus Resistance Check: With the battery disconnected, measure resistance across the CAN High (CAN-H) and CAN Low (CAN-L) lines at a diagnostic connector. A healthy bus should read approximately 60 Ohms. 120 Ohms suggests a missing termination resistor or a break in the wiring. Significantly lower than 60 Ohms indicates a short between lines or a faulty ECU

  5. Use a diagnostic tool to check for any other active fault codes (such as U-codes) to help pinpoint the location of the communication issue

Repair steps

  1. Isolate the faulty component

    If initial checks do not reveal an obvious wiring issue, use the node isolation method. Disconnect one control module from the CAN network at a time and re-check the bus resistance to see if the network returns to a healthy state (approx. 60 Ohms).

  2. Repair harness and connectors

    If a damaged section of the wiring harness or a faulty connector is identified, repair or replace it. Ensure all connections are clean and secure.

  3. Inspect Engine ECU

    If the wiring and other nodes are ruled out, inspect the Engine ECU's connectors for any signs of damage or corrosion.

  4. Replace Engine ECU

    If the Engine ECU is determined to be faulty, it will require replacement. Note that a blank ECU will need to be programmed for the specific machine.

Parts you might need

(5)
  • Engine Control Unit (Blank)

    320/C9992

    Blank ECU for Delphi DCM 7.24 systems used in EcoMAX 444, 448, and 430 engines. Requires programming.

  • Second-hand Engine Control Module. Always verify fitment with the machine's serial number.

  • Wiring Harness

    Specific to machine model. Required if a section of the CAN bus harness is damaged beyond repair.

  • Connectors

    Damaged diagnostic or ECU connectors may need to be replaced.

  • CAN Bus Termination Resistor

    May be a separate, replaceable component located near the ECU depending on configuration.

Get help to fix this fault by requesting a quote

Browse other JCB codes