P256B

JCB P256B – ECU: Engine Idle Speed Selector Sensor/Switch Range/Performance Issue

Issue description

The Engine Control Unit (ECU) has detected an implausible signal from the engine idle speed selector sensor or switch. While the signal is operating within its expected electrical limits, it does not correspond with the values the ECU anticipates under the current operating conditions. This indicates a performance issue with the sensor or the integrity of its circuit, which directly affects the machine's ability to correctly set and maintain the proper engine idle speed.

Applies to these machines

  • Loadall Telescopic Handlers
  • Excavators
  • Machines with EcoMAX Engines
  • Machines with Tier 4 Engines

Check the cause

  1. Visually inspect the wiring harness associated with the engine speed controller for chafing, cuts, heat damage, or pinching

  2. Disconnect the engine idle speed selector sensor/switch connector and inspect terminals for corrosion, moisture ingress (often from pressure washing), debris, or bent/loose pins

  3. Check for damaged or loose machine earth connections, as poor grounds can cause erratic sensor readings

  4. Clear the fault code and operate the machine to determine if the fault is intermittent

Repair steps

  1. Prepare machine

    Ensure the engine is stopped and has had sufficient time to cool down before proceeding with any service procedures.

  2. Test sensor/switch

    Using a multimeter, check for the correct voltage supply to the sensor and verify that the signal output changes appropriately as the idle speed selector is operated.

  3. Replace sensor/switch

    If preliminary checks and multimeter testing confirm the engine idle speed selector sensor/switch is faulty, replace the component.

Parts you might need

(2)
  • Verify correct part number based on machine serial number through an authorized dealer.

  • Rocker Switch701/60003

    Fits various JCB Loaders and Telescopic Handlers. Verify correct part number based on machine serial number.

Get help to fix this fault by requesting a quote

Browse other JCB codes