P2BAA-92

JCB P2BAA-92 – Aftertreatment System ECU or Engine ECU: Consumption Level1 Enacted

Issue description

The engine's control system has detected an issue with the consumption of Diesel Exhaust Fluid (DEF) and enacted a 'Level 1' inducement. This indicates that the Selective Catalytic Reduction (SCR) system is not using enough DEF to neutralize Nitrogen Oxides (NOx), resulting in high NOx emissions and a lower-than-expected drop in the DEF tank level. As a corrective action, the system activates a specific operational mode that imposes a 25% engine torque derate, causing a noticeable loss of power and illuminating a dashboard warning light.

Applies to these machines

  • JCB EcoMAX Tier 4 Final engines
  • JS Tracked Excavators with SMART Controls

Check the cause

  1. Check for and diagnose any other active fault codes first, as they may be the root cause of the inducement

  2. Verify the ECU software is up to date

  3. Perform a DEF quality test to check for contamination or poor fluid concentration

  4. Inspect the aftertreatment wiring harness and connectors for damage, loose pins, moisture ingress (from pressure washing), or corrosion ('green death')

  5. Trace DEF lines from the tank to the injector, looking for leaks or white, crusty buildup of crystallized DEF

  6. Remove the DEF injector from the exhaust pipe and inspect the tip for a clogged nozzle or crystallized DEF buildup

Repair steps

  1. Clean DEF injector

    If the DEF injector nozzle is clogged with crystallized DEF, clean it using warm water and carefully reinstall.

  2. Test dosing system

    Using JCB ServiceMaster, perform a 'DEF Doser Pump Override' test. A healthy system will produce a wide mist of DEF. If it only drips or does nothing, there is a physical blockage or failed component.

  3. Check related sensors

    If the dosing test fails or the code persists, check related components like the DEF tank level sensor and temperature sensor for faults.

  4. Replace faulty components

    If the DEF dosing module (pump) or DEF injector is confirmed to be faulty and cannot be cleaned, replace the affected component.

Parts you might need

(7)
  • Bosch 0444043081, DM 2.5 dosing module for Tier 4 and Stage V

  • DEF Dosing Module

    400/U8463

    Alternative dosing module part number

  • Alternative dosing module part number

  • For Stage V engines

  • Fuel Injector320/06827

    For 56-93KW Tier 4 Diesel Max and Eco Max engines. Note: Engine fuel injector, not DEF injector.

  • Fuel Injector

    320/06881

    For Tier 4, 55kw DieselMax and EcoMax engines. Note: Engine fuel injector, not DEF injector.

  • Fuel Injector

    320/06828

    For 4.8L Ecomax Engines. Note: Engine fuel injector, not DEF injector.

Get help to fix this fault by requesting a quote

Browse other JCB codes