P2BAE-68

JCB P2BAE-68 – ECU: System Tampering Level 2 Enacted

Issue description

The engine's control system has detected a significant and persistent issue within the aftertreatment system, leading to excessive NOx emissions. This is classified as an 'Event Information' fault. The system interprets the ongoing high NOx levels as a potential tampering event, escalating it to a 'Level 2' severity. The underlying condition is a NOx exceedance, which triggers an operator warning and can lead to an engine derate to ensure emissions compliance.

Applies to these machines

  • JS190
  • 419S
  • 437

Check the cause

  1. Inspect wiring harnesses and connectors for NOx sensors, DEF injector, and aftertreatment ECU for rubbing, melting, corrosion ('green death'), or damaged pins

  2. Check DEF (AdBlue) tank level and verify the fluid is not empty, overfilled, contaminated, or of poor quality

  3. Inspect the DEF dosing valve and injector for contamination, blockages, or malfunction

  4. Examine upstream and downstream NOx sensors for physical damage, dirt, or soot accumulation

  5. Inspect the exhaust system for any leaks between the engine and the aftertreatment system components

Repair steps

  1. Address preliminary faults

    Use the JCB Service Master diagnostic tool to check for other active fault codes related to NOx sensors or the DEF injector. Diagnose and repair these specific component faults first.

  2. Test suspect components

    If visual inspection reveals no obvious issues, use a multimeter to check sensor resistance or voltage outputs against OEM specifications.

  3. Replace faulty components

    Replace any identified faulty NOx sensors. Clean or replace the DEF injector if clogged or electrically failed. Repair or replace any damaged sections of the wiring harness.

  4. System reset and verification

    Clear the P2BAE-68 code using the JCB Service Master tool. Run the machine and monitor the system to ensure the fault does not return. An aftertreatment ECU software update or re-flash may be necessary.

Parts you might need

(7)
  • NOx Sensor

    400/02667

    Example part number for 419S/437 models. Alternatives: 400/20459, 400/02675, 400/02668R (Reman)

  • DEF Doser / Injector

    400/24969

    Example part number for 419S model

  • DEF Quality Sensor

    Generic DEF quality sensor

  • Aftertreatment Temperature Sensor

    400/02669

    Example part number for 419S/437 models. Alternative: 400/03341

  • SCR Unit

    334/T3768

    Example part number for 437 model

  • Decomposition Reactor

    334/T3763

    Example part number for 437 model

  • AdBlue Filter Kit

    Generic AdBlue filter kit

Get help to fix this fault by requesting a quote

Browse other JCB codes