P3406-87

JCB P3406-87 – Aftertreatment System ECU or Engine Control Unit (ECU): Aftertreatment 1 SCR Catalyst DEF Properties - Temperature Too Low

Issue description

The system has detected that the temperature of the Diesel Exhaust Fluid (DEF) is too low for the aftertreatment 1 Selective Catalytic Reduction (SCR) catalyst to function properly. The SCR system requires DEF to be within a specific temperature range to effectively react with exhaust gases and reduce NOx emissions. If the temperature is too low, emissions control efficiency is compromised, which can trigger engine performance limitations.

Applies to these machines

  • Tracked and Wheeled Excavators (JS Series)
  • Wheel Loaders (406SV, 409SV)
  • Backhoe Loaders
  • Telehandlers

Check the cause

  1. Verify ambient temperature to determine if the machine has been operating in severe cold (DEF freezes at -11°C or 12°F, which will trigger this fault)

  2. Check for related active or stored fault codes, such as P3407-87 (open circuit) or P3408-87 (short circuit), which can pinpoint a sensor or wiring issue

  3. Inspect the wiring harness and connectors leading to the DEF tank temperature sensor for damage, moisture, loose pins, or corrosion (often appearing as white or green residue)

  4. Check the DEF tank and associated lines for any signs of leaks or physical damage

  5. Test DEF quality using a refractometer to ensure the concentration is at 32.5%

  6. Test the DEF temperature sensor's resistance using a multimeter to check for an open or shorted circuit (sensor is often integrated into the DEF level/quality unit)

  7. Check the DEF tank heater and coolant control valve to ensure warm engine coolant is properly circulating through the DEF tank heater

Repair steps

  1. Address environmental factors

    If the fault is due to extreme cold, allow the machine to warm up to see if the fault clears. Ensure any DEF tank heating systems are operational.

  2. Repair wiring and connectors

    If damage or corrosion was found during the visual inspection, repair or replace the affected sections of the wiring harness or connectors. Ensure all connections are clean and secure.

  3. Replace DEF temperature sensor assembly

    If the sensor is diagnosed as faulty, replace the combined DEF tank unit. Disconnect the battery, drain the DEF tank, disconnect electrical and coolant lines, and unbolt the sensor assembly. Install the new assembly with a new gasket, reconnect all lines, and refill with fresh, high-quality DEF.

  4. Replace coolant control valve

    If the coolant control valve for the DEF heating circuit is found to be faulty and preventing warm coolant from circulating, replace the valve.

  5. Clear fault codes and verify

    Reconnect the battery, start the engine, and use a diagnostic tool to clear the fault codes. Operate the machine to ensure the fault does not return. It may require several drive cycles for the ECU to verify the fix.

Parts you might need

(4)
  • Multi-function unit including level, quality, and temperature sensing. Verify OEM part number with dealer using machine serial number.

  • DEF Tank Sensor Temperature

    400/03341

    Listed in aftertreatment diagrams for models like the 437 Wheel Loader.

  • Common 2-pin coolant temperature sensor (reference part, may not be the primary DEF sensor).

  • Module Doser Fluid Supply

    400/24969

    Aftertreatment module listed for some models.

Get help to fix this fault by requesting a quote

Browse other JCB codes