P3415-87

JCB P3415-87 – DCU: Data Length Error for IC1 Frame

Issue description

The system has detected a data length error for the IC1 frame on the CAN bus, meaning the received message is not the expected size. This indicates a potential issue with communication or data integrity affecting the Dosing Control Unit (DCU), which manages AdBlue injection for the Selective Catalytic Reduction (SCR) system.

Applies to these machines

  • JS115
  • JS130
  • JS145
  • JS160
  • JS180
  • JS190
  • JS200
  • JS210
  • JS220
  • JS235
  • 527
  • 535
  • 550
  • Wheeled Loaders
  • Generators
  • Lighting Towers

Check the cause

  1. Visually inspect the wiring harness connected to the Dosing Control Unit (DCU) for rubbing, fraying, melting, or physical damage.

  2. Unplug the main connector to the DCU and check for corrosion (often green), bent pins, water ingress, or debris, especially if the engine bay was recently pressure washed.

  3. Check all machine and engine ground straps to ensure they are clean, tight, and free from corrosion, as poor grounding causes electronic faults.

  4. Verify that the wiring harness is routed correctly and secured away from sharp edges or high heat sources.

  5. Clear the fault code and monitor; if it reappears immediately, it indicates a persistent hardware or wiring issue.

Repair steps

  1. Stop the engine

    Ensure the engine is stopped and cooled down before beginning any work.

  2. Repair wiring

    If any damage is found on the wiring harness, such as chafing or breaks, repair the affected wires. Ensure all repairs are insulated and protected from the elements.

  3. Clean connectors

    If corrosion or debris is found in the connectors, clean them using an appropriate electrical contact cleaner. Ensure they are completely dry before reconnecting.

  4. Secure connections

    Reconnect the harness to the Dosing Control Unit, ensuring a secure and positive lock.

  5. Replace Dosing Control Unit

    If the wiring and connectors are in good condition and the fault persists, replace the Dosing Control Unit (DCU).

Parts you might need

(1)
  • Genuine JCB part. Also referenced by model number DCU-17CV51. Component of the aftertreatment system for Tier 4 and Stage V engines.

Get help to fix this fault by requesting a quote

Browse other JCB codes