P3416-87

JCB P3416-87 – DCU: Time Out Error for IC1 Frame

Issue description

The Dosing Control Unit (DCU) has detected a timeout error for the IC1 frame, indicating a Missing Message (FMI 87). A specific data message expected from another control unit on the CAN bus network did not arrive within the specified timeframe. This communication breakdown can prevent the proper functioning of the aftertreatment system.

Applies to these machines

  • JCB Ecomax Tier 4 engines
  • JS Series Crawler Excavators
  • JS Series Wheeled Excavators
  • JS130
  • JS160
  • Backhoe Loaders
  • Loadall Telehandlers
  • Other equipment utilizing the JCB Tier 4 Final and Tier 4 Interim engines

Check the cause

  1. Check battery voltage and ensure the charging system is functioning correctly, as low system voltage can trigger spurious communication faults

  2. Visually inspect the wiring harness and connectors between the Dosing Control Unit (DCU) and the main Engine ECU for rubbing, fraying, melting, or damage

  3. Disconnect the connectors at the DCU and inspect for corrosion (green or white powder), bent or loose pins, and the presence of water or debris

  4. Verify that all main ground connections for the cab, engine, and chassis are clean, tight, and free from corrosion

  5. Use JCB ServiceMaster to check for other active or historic fault codes, specifically related CAN bus communication codes (U-series) to help pinpoint the network failure

Repair steps

  1. Isolate the Faulty Component

    The fault is a communication timeout, so the issue lies in the DCU itself, the wiring to the DCU, or another module on the CAN bus that is failing to send the required message.

  2. Troubleshoot CAN bus

    If possible, use JCB ServiceMaster to monitor the CAN bus network and identify which ECU is not communicating. Check the CAN bus termination resistors. A properly terminated CAN bus should have a resistance of approximately 60 ohms when measured across the CAN high and CAN low lines (with the battery disconnected).

  3. Test harness continuity

    Perform a point-to-point continuity test on each wire in the harness section connecting the Engine ECU to the Aftertreatment DCU. Check for open circuits (no continuity) and short circuits (continuity to ground or to other wires).

  4. Update software

    In some instances, communication issues can be resolved by updating the software for the Engine ECU and the Dosing Control Unit. This requires the JCB ServiceMaster tool.

  5. Replace Dosing Control Unit

    If the wiring and connections are confirmed to be in good condition and the software is up to date, the fault may lie with the Dosing Control Unit itself. Replace the DCU and clear the fault codes.

Parts you might need

(7)
  • Listed for various JS-series excavators and Centremount models

  • Dosing Control Unit (DCU) / Dosing Module

    250/A9105

    Listed as DM 2.5 Dosing Module

  • Dosing Control Unit (DCU) / Dosing Module

    320/B6328
  • Dosing Module Kit for Stage V engines

  • Engine / Aftertreatment Wiring Harness

    320/09890

    Engine harness for Tier 4 interim 55kW engines

  • Engine / Aftertreatment Wiring Harness

    320/09953

    Engine harness for Tier 4 Final 56kW engines

  • Engine / Aftertreatment Wiring Harness

    721/E0414

    Harness Engine Tier 4 Final

Get help to fix this fault by requesting a quote

Browse other JCB codes