P3419-87

JCB P3419-87 – Aftertreatment System ECU: Error for Particulate Inlet Pressure

Issue description

The Aftertreatment System ECU has detected an error with the signal from the sensor monitoring the pressure at the inlet of the Diesel Particulate Filter (DPF). The DPF differential pressure sensor measures exhaust back pressure before and after the DPF to calculate the amount of trapped soot. An incorrect value transmitted by this sensor triggers the code, indicating an issue that affects the proper operation of the emissions system.

Applies to these machines

  • JS Series Tracked Excavators
  • JS Series Wheeled Excavators
  • EcoMAX Tier 4 Engine Machines
  • EU Stage V Engine Machines

Check the cause

  1. Stop the engine, allow it to cool completely, and disconnect the battery for safety before beginning any work.

  2. Visually inspect the two pressure hoses connected to the DPF pressure sensor for melting, cracks, kinks, soot blockage, or moisture contamination. Ensure they are securely connected and routed away from high-heat sources. Lightly sooted hoses can be cleaned; brittle or damaged hoses must be replaced.

  3. Check the sensor's electrical connector and pins for any damage, corrosion, debris, or water ingress. Ensure the connector is securely fastened.

  4. Examine the wiring harness leading to the sensor for any signs of damage, such as chafing, breaks, or heat damage from improper routing.

  5. With the key on but the engine off, use a diagnostic tool to read the DPF differential pressure sensor signal voltage. At an ambient temperature of 25°C (77°F) and below, the voltage should typically be between 0.61 and 0.77 VDC.

Repair steps

  1. Access the sensor

    Locate the DPF differential pressure sensor. It is typically mounted in the engine compartment to protect it from excessive heat.

  2. Disconnect electrical connector

    Disconnect the electrical connector from the sensor.

  3. Remove hoses

    Carefully disconnect the two pressure hoses, noting which hose connects to the upstream (inlet) and downstream (outlet) ports of the sensor.

  4. Unbolt sensor

    Remove the bolts or screws securing the sensor to its mounting bracket.

  5. Install new sensor

    Mount the new sensor and secure it with its bolts or screws.

  6. Reconnect hoses and wiring

    Reconnect the two pressure hoses to the correct ports on the new sensor, then plug the electrical connector back in.

  7. Clear codes and verify

    Reconnect the battery. Use a diagnostic tool to clear the fault code and check if the issue is resolved.

Parts you might need

(2)
  • DPF differential pressure sensor

    400/02521

    Listed specifically as a DPF differential pressure sensor.

  • Potentially related, but 400/02521 appears to be the more specific part for the DPF system.

Get help to fix this fault by requesting a quote

Browse other JCB codes