P3420-87

JCB P3420-87 – Aftertreatment System ECU: Data Length Error for PROSCR3 Frame Received for Regeneration

Issue description

A communication error has occurred on the machine's CAN bus network. A data message related to the selective catalytic reduction (SCR) system during the regeneration process (PROSCR3 frame) was received with an incorrect or unexpected length. This indicates an inconsistency in the data transmission or structure, suggesting an issue with the integrity of the data being transmitted between control modules.

Applies to these machines

  • Tier 4 EcoMAX Engine Machines
  • Tracked Excavators
  • Wheeled Excavators
  • Backhoe Loaders
  • Telehandlers
  • Compactors
  • Wheeled Loaders

Check the cause

  1. Visually inspect the wiring harness and connectors associated with the Aftertreatment System ECU for chafing, corrosion, loose pins, or water/debris ingress (especially from pressure washing)

  2. Check all machine earth connections to ensure they are clean, tight, and free from corrosion

  3. Verify that the wiring harness is routed correctly and is not stretched, pinched, or rubbing against sharp edges

Repair steps

  1. Stop the engine

    Ensure the engine is stopped and the machine has completely cooled down before beginning any work.

  2. Inspect and clean connectors

    Disconnect the main connector for the Aftertreatment System ECU. Inspect the pins and terminals on both the harness side and the ECU side for damage, moisture, or debris. Clean the connectors as necessary.

  3. Inspect wiring harness

    Trace the wiring harness from the Aftertreatment System ECU back to the main Engine ECU, looking for any visible damage. Repair or replace the harness section if damage is found.

  4. Check earth straps

    Locate and verify the integrity of the main earth straps for the engine and chassis, as a poor ground connection can cause electronic faults.

  5. Clear fault codes

    After performing inspections, cleaning, and minor repairs, reconnect all components. Clear the fault codes using a diagnostic tool.

  6. Test operation

    Start the machine and attempt to initiate a stationary regeneration. If the code does not reappear, it was likely a poor connection. If the fault code persists after verifying wiring and connections, the Aftertreatment ECU itself may be faulty.

Parts you might need

(2)
  • Aftertreatment System ECU

    Contact a JCB dealer with the machine's serial number for the correct OEM part number.

  • Engine to Aftertreatment Wiring Harness

    Contact a JCB dealer with the machine's serial number for the correct OEM part number.

Get help to fix this fault by requesting a quote

Browse other JCB codes