P3421-87

JCB P3421-87 – ECU: Timeout Error for PROSCR3 Frame Received for Regeneration

Issue description

A timeout error has occurred for the PROSCR3 frame during the DPF regeneration process. The Engine Control Unit (ECU) did not receive the expected communication or data message from the Aftertreatment Control Module within the allowed time period. This indicates a Controller Area Network (CAN bus) communication failure rather than a mechanical component failure. As a result of this lost communication, the machine will typically reduce engine torque and power, potentially entering limp mode to prevent damage.

Applies to these machines

  • Tracked & Wheeled Excavators (like the JS series)
  • Telehandlers
  • Backhoe Loaders

Check the cause

  1. Record and clear the fault code using JCB ServiceMaster to determine if the code is intermittent or triggered by a temporary low voltage event.

  2. Check battery and electrical system health, ensuring the battery is fully charged and all terminals and ground straps are clean, tight, and free of corrosion.

  3. Visually inspect the wiring harness routed between the Engine ECU and the Aftertreatment Control Module for rubbing, chafing, melting, or physical damage (especially near hot exhaust components or sharp edges).

  4. Inspect electrical connectors at both the Engine ECU and Aftertreatment Control Module for corrosion (green/white powder), bent pins, or moisture intrusion.

  5. Verify CAN bus network integrity by measuring resistance between the CAN High and CAN Low wires with the battery disconnected (a healthy CAN bus should read approximately 60 Ohms).

  6. Check for available software updates for the Engine ECU or Aftertreatment Control Module using dealer diagnostic software.

Repair steps

  1. Address basic electrical issues

    If low battery voltage, loose grounds, or corroded terminals were found, charge or replace the battery and clean/tighten all connections. Clear codes and test operate the machine.

  2. Repair damaged wiring

    If the harness is chafed, melted, or broken, repair the affected wires using high-quality sealed connectors and heat shrink. Replace the entire harness section if the damage is severe.

  3. Clean or replace connectors

    Use specialized electrical contact cleaner to remove any corrosion from connector pins. If pins are severely damaged or broken, replace the connector or the entire harness.

  4. Update module software

    If software updates are available, use the JCB ServiceMaster tool to flash the new software to the Engine ECU or Aftertreatment Control Module.

  5. Replace control module

    If wiring, connections, and software are verified good, the fault may lie within the Engine ECU or Aftertreatment Control Module. Substitute a known-good module to isolate the failed component. Program the new module to the machine's serial number.

Parts you might need

(3)
  • Wiring Harness

    Specific part number depends on machine model and serial number. Repairing the existing harness may be possible rather than full replacement.

  • Engine Control Unit (ECU / ECM)

    Machine-dependent part number. Requires programming to the machine's serial number using dealer-level software.

  • Aftertreatment Control Module

    Controls SCR and DPF systems. Machine-specific part number; requires programming upon installation.

Get help to fix this fault by requesting a quote

Browse other JCB codes