JCB P3422-87 – ECU: Erroneous Soot Load Message Signal
Issue description
The Engine Control Unit (ECU) is receiving an illogical or incorrect signal related to the calculated soot load in the Diesel Particulate Filter (DPF). Because the soot load is not measured directly but calculated using data from the DPF differential pressure sensor, this fault indicates a problem with the sensor, its wiring, or the connecting hoses. An erroneous signal can prevent the DPF from regenerating correctly, potentially leading to reduced engine torque, excessive smoke, or the machine entering limp mode to prevent damage.
Applies to these machines
4 machines- Tier 4 Ecomax Engine Machines
- Backhoe Loaders
- Telehandlers
- Excavators
Check the cause
Visually inspect the two hoses connected to the DPF differential pressure sensor for melting, cracks, kinks, blockages from soot or moisture, and ensure secure connections.
Examine the wiring harness and electrical connector for the DPF pressure sensor for chafed or broken wires, loose connections, or corrosion (often appearing as green powder).
Check for other active fault codes using a diagnostic scanner, such as CAN bus communication errors, which could indicate a broader electrical issue.
Verify engine oil and other critical fluid levels, as low levels can sometimes trigger seemingly unrelated fault codes.
Repair steps
Clear codes and retest
Using a diagnostic tool, clear the active fault code and operate the machine. If the code does not immediately return, the issue may have been intermittent.
Test sensor voltage
With the ignition on but the engine off, back-probe the DPF pressure sensor connector with a multimeter. Verify the presence of a 5-volt reference wire, a ground wire (0 volts), and a signal wire (typically reading around 0.5V at idle, though consult the specific service manual for exact pinouts).
Test sensor under pressure
With the engine running, monitor the signal voltage as you increase engine RPM. The voltage should rise with the increased exhaust flow. Alternatively, use a handheld vacuum/pressure pump on the sensor's intake port to verify the voltage reading changes. If the voltage does not change or is out of range, the sensor is likely faulty.
Check for blockages
If the sensor and wiring are good, remove the hoses and pass air through them to ensure they are completely clear. Check the pressure ports on the DPF itself for hard soot deposits. Do not use hard tools that could damage the ports.
Replace components
Replace the DPF differential pressure sensor if it failed testing. Repair or replace any damaged wiring or hoses. After replacement, clear the fault codes and run the machine to confirm the repair.
Parts you might need
(2)DPF Differential Pressure Sensor
400/02521OEM JCB part. Verify correct part number for the specific machine's serial number.
DPF Differential Pressure Sensor
400/16479OEM JCB part. Verify correct part number for the specific machine's serial number.
Get help to fix this fault by requesting a quote