U0029-87

JCB U0029-87 – ECU: CAN Bus Communication Failure at 250kbps

Issue description

The system has detected a CAN bus communication failure at a speed of 250kbps. The '-87' suffix denotes a 'Missing Message' condition, indicating that a critical data message between electronic control units (ECUs) was not received as expected. This signifies a loss of communication within the affected circuit, preventing proper data exchange between components, which can lead to warning lights on the dash or reduced machine performance (derate).

Applies to these machines

  • JS Series Tracked Excavators
  • JS Series Wheeled Excavators
  • Backhoe Loaders

Check the cause

  1. Record and clear the code using a diagnostic tool to observe if it returns immediately, suggesting a persistent hardware fault

  2. Check battery and ground health to ensure the battery is fully charged (above 12.5V) and all connections/ground straps are clean and tight

  3. Visually inspect the CAN bus wiring harness for physical damage such as chafing, cuts, kinks, or heat damage

  4. Inspect connectors for the ECUs on the 250kbps network for corrosion (green/white powder), bent pins, or moisture intrusion

  5. Measure CAN bus resistance by powering down the machine, disconnecting the battery, and measuring across the CAN High and CAN Low wires (expected reading is approximately 60 Ohms)

Repair steps

  1. Address preliminary findings

    Rectify any issues found during initial checks, such as charging a low battery, cleaning or replacing corroded connectors, and repairing damaged sections of the wiring harness. Clear the fault codes and re-test.

  2. Isolate faulty component

    If the CAN bus resistance reading is incorrect (e.g., 120 Ohms or 0 Ohms), disconnect each ECU on the 250kbps bus one by one. If disconnecting a specific ECU causes the resistance to return to the correct value, that ECU's internal circuitry is likely faulty. If disconnecting all ECUs does not correct the reading, the fault lies within the wiring harness.

  3. Check terminating resistors

    Locate the two 120-Ohm terminating resistors on the CAN bus (often near the ends of the main harness). Test them individually and replace any resistor that does not measure exactly 120 Ohms.

  4. Replace faulty ECU

    If a specific ECU is identified as the source of the short or communication failure, replace it with the correct part for the machine's model and serial number. Program the new ECU with the appropriate software.

Parts you might need

(3)
  • Alternative OEM part number: 478/02003. Standard resistance is 120 Ohms.

  • Wiring Harness

    No specific part numbers provided as they are unique to the machine's configuration. Repair existing harness if practical.

  • Engine Control Unit (ECU) / Aftertreatment Control Unit

    Part numbers are highly specific to the machine model, serial number, and engine type.

Get help to fix this fault by requesting a quote

Browse other JCB codes