U0073

JCB U0073: Control Module Communication Bus A Off

Issue description

A communication error has been detected on the CAN Bus, which is responsible for transmitting data between electronic control units within the system. This critical communication failure indicates that one or more essential modules (such as the ECM, TCM, or instrument cluster) has stopped communicating, leading to a variety of potential machine malfunctions.

Applies to these machines

  • 3CX
  • JS220
  • 531-70

Check the cause

  1. Record and clear fault codes to determine if the U0073 code is intermittent or returns immediately.

  2. Check battery and electrical system health (verify battery is fully charged to at least 12.4V at rest and charging system outputs 13.8V to 14.5V when running).

  3. Inspect battery terminals, main ground straps, and all relevant control module fuses for cleanliness and tightness.

  4. Visually inspect the main engine-to-chassis wiring harness for rubbing, fraying, melting, or physical damage.

  5. Inspect large, multi-pin connectors (especially under the cab) for corrosion ('green death'), bent pins, or water ingress.

  6. Check CAN Bus resistance with ignition OFF and battery disconnected (measure between Pin C and Pin D on the 9-pin diagnostic port; should read approximately 60 Ohms. A reading of 120 Ohms suggests an open circuit, while a reading significantly lower than 60 Ohms indicates a short circuit).

Repair steps

  1. Isolate the faulty module or harness

    Connect the JCB ServiceMaster tool to identify which specific modules are offline. If a specific module is offline, focus on its wiring. If multiple are offline, inspect the common main CAN bus harness or primary control units like the MECU or PECU.

  2. Repair harness and connectors

    Disconnect any corroded connectors and clean pins/sockets with electrical contact cleaner. Replace severely damaged pins or connectors. Repair chafed or broken wires by soldering and sealing with heat shrink tubing.

  3. Check CAN cable continuity

    Perform a continuity test on the CAN High and CAN Low wires from end to end (looking for near-zero resistance). Check for shorts between CAN High and ground, CAN Low and ground, and between CAN High and CAN Low.

  4. Replace faulty control module

    If all wiring and connections are good and the fault persists, replace the failed control module (MECU, PECU, or ECM). Consult a JCB dealer to confirm diagnosis and program the new module using ServiceMaster.

  5. Final verification

    Reconnect the battery, clear all fault codes, run the machine under load, and use the diagnostic tool to verify all modules are communicating and the U0073 code does not return.

Parts you might need

(4)
  • Engine-to-Chassis Harness

    Specific to machine model and configuration; consult dealer with serial number.

  • JCB Controller, MECU

    460/31902

    Generic reference part number only. Requires dealer programming via ServiceMaster.

  • Connectors and Pins

    Deutsch or other OEM connectors for harness repair.

  • Terminating Resistor

    120-Ohm resistor; may be integrated into a harness or control unit.

Get help to fix this fault by requesting a quote

Browse other JCB codes