U0101

JCB U0101 – Powertrain Control Module (PCM) or Engine Control Module (ECM): CAN Timeout Fault

Issue description

The system has detected a CAN timeout fault, indicating a loss of communication within the CAN network. A control module expecting to receive data from the Transmission Control Module (TCM) has not received a message within the expected timeframe. This fault affects the ability of the controller to receive or transmit data properly, signaling that the communication link is broken because the TCM has stopped broadcasting its status or responding to network requests.

Applies to these machines

  • JS Excavator
  • 3CX
  • 4CX
  • Tracked Excavators
  • Wheeled Excavators

Check the cause

  1. Scan for all trouble codes using a compatible diagnostic scanner to check for other 'U' codes that might indicate a wider network problem rather than an isolated TCM issue

  2. Check battery and charging system to ensure the battery is fully charged, terminals are clean and tight, and the alternator is providing stable voltage (typically 12.5V+ with engine off, and higher when running)

  3. Inspect all fuses and relays related to the transmission and its control module for blown fuses that could cut power to the TCM

  4. Visually inspect the wiring harness and connectors connected to the TCM for rubbing, fraying, melting, corrosion ('green death'), or bent/loose pins

Repair steps

  1. Verify TCM power and ground

    Using a multimeter, confirm the TCM connector receives correct battery voltage at its power supply pins with the ignition on. Measure resistance between the ground pins and chassis; it should be less than 0.5 Ohms.

  2. Test CAN bus network resistance

    With the machine's battery disconnected, measure resistance between CAN High and CAN Low pins at the diagnostic port or the TCM connector. A healthy bus reads approximately 60 Ohms. 120 Ohms indicates a missing termination resistor or break; near 0 Ohms indicates a short circuit.

  3. Test CAN bus network voltage

    With the ignition on, measure voltage on the CAN lines. CAN High should be 2.5 to 3.0 volts, and CAN Low should be 2.0 to 2.5 volts. Incorrect voltages indicate a faulty module pulling the bus voltage down.

  4. Isolate the faulty module

    If wiring, power, and grounds are good, disconnect modules from the CAN network one by one. If bus resistance returns to 60 Ohms after disconnecting the TCM, it is the likely source of the fault.

  5. Re-flash or replace the TCM

    If all network and wiring tests pass, have a dealer re-flash the TCM with updated software. If unsuccessful, replace the Transmission Control Module.

Parts you might need

(3)
  • Transmission Control Module (TCM)

    Third-party supplier lists 701/70001 for 3CX/4CX, but verify OEM fitment by serial number. Requires dealer programming.

  • Transmission Wiring Harness

    Must be an exact match for the machine's model and serial number.

  • CAN Bus Termination Resistor

    Typically 120-Ohm resistors integrated into the wiring harness or control units.

Get help to fix this fault by requesting a quote

Browse other JCB codes