U0105-87

JCB U0105-87: CAN Bus Message Error for Fuel Quantity from Engine ECU

Issue description

The fault code U0105-87 indicates a communication breakdown on the machine's Controller Area Network (CAN) bus where a control module is not receiving the expected fuel quantity data message from the Engine Control Unit (ECU). The '-87' suffix signifies a 'missing message', meaning the Engine ECU failed to transmit the data within the expected timeframe. This represents a loss of communication rather than a direct fuel system component failure, and often results in a reduction in engine torque to ensure safe operation.

Applies to these machines

  • JS130W
  • JS145W
  • JS160W
  • JS175W
  • JS200
  • JS220
  • JZ140

Check the cause

  1. Record and clear the fault code to see if it returns immediately, as some communication codes can be intermittent or triggered by temporary low voltage

  2. Check battery and power supply voltage, ensuring the battery is fully charged and all power/ground connections to the ECUs are clean and tight

  3. Visually inspect the CAN bus wiring harness between the Engine ECU and other control modules for chafing, melting, or corrosion

  4. Inspect main connectors at the Engine ECU and receiving modules for corrosion, moisture intrusion, or bent pins

  5. Perform a CAN bus network integrity check by measuring resistance between CAN High and CAN Low with the ignition off. A healthy network is approximately 60 Ohms; around 120 Ohms suggests a missing terminating resistor or open circuit, and near 0 Ohms indicates a short circuit.

Repair steps

  1. Address basic power and wiring issues

    Repair any found issues with battery voltage, grounds, or visible wiring damage. Clean corroded connectors and ensure all connections are secure. Clear the codes and re-test the machine.

  2. Isolate faulty harness section

    If the CAN bus resistance is incorrect (e.g., 120 Ohms indicating a missing resistor/open circuit, or 0 Ohms indicating a short), consult a wiring diagram to locate terminating resistors and major harness connection points. Disconnect sections of the harness and re-measure resistance to isolate the fault.

  3. Test individual modules

    If wiring is confirmed intact and the fault persists, use advanced diagnostic tools like JCB ServiceMaster to monitor live CAN bus traffic and determine which module (Engine ECU or receiving module) is failing to communicate.

  4. Replace faulty module

    If a module is identified as internally faulty and unable to transmit or receive messages, replace it. Do not replace the Engine ECU without first performing thorough wiring and network checks.

Parts you might need

(5)
  • Engine Control Unit (ECU)

    728/35700

    Fits various JS excavators. Requires programming by a certified dealer.

  • For JS and JZ series excavators. Requires programming by a certified dealer.

  • Engine Control Unit (ECU)

    728/15500

    Requires programming by a certified dealer.

  • Wiring Harness

    Specific to machine model and serial number.

  • Terminating Resistor

    Often integrated into the harness or a specific connector.

Get help to fix this fault by requesting a quote

Browse other JCB codes