U0110

JCB U0110 – ECM: Engine Rating TO

Issue description

The Engine Control Module (ECM) or another critical control unit has lost communication with a component of the Selective Catalytic Reduction (SCR) system on the CAN bus network. This communication timeout prevents the system from verifying the correct engine rating or operational state of the after-treatment system, causing the machine to enter an inducement mode that derates engine power or shuts it down to ensure emissions compliance.

Applies to these machines

  • JS110
  • JS130
  • JS220
  • 427
  • 437
  • Backhoe Loaders
  • Telehandlers

Check the cause

  1. Check for other active or stored fault codes using a diagnostic scanner, especially CAN bus errors, power supply issues, or sensor failures

  2. Verify battery voltage is fully charged (above 12.5V) and check that all power and ground connections to the ECM and related modules are clean and tight

  3. Visually inspect the wiring harnesses connected to the ECM, Dosing Control Unit (DCU), and DEF/AdBlue injector for rubbing, chafing, melting, or other damage

  4. Inspect the main connectors for the ECM and related modules for corrosion (green/white powder), bent or broken pins, and moisture intrusion

  5. Measure CAN bus termination resistance between CAN high and CAN low wires at the diagnostic port with the machine powered off (should be approximately 60 ohms; 120 ohms indicates an open circuit/missing resistor, while significantly lower indicates a short)

Repair steps

  1. Address other faults

    Diagnose and repair any other present fault codes first, as they may be the root cause of the U0110 communication timeout.

  2. Repair wiring and connectors

    Repair or replace any damaged sections of the wiring harness or connectors found during inspection. Clean connectors with contact cleaner and ensure all connections are secure and protected from the elements.

  3. Isolate faulty module

    If wiring and power supply are confirmed good, disconnect modules from the CAN bus one by one to see if the communication fault resolves. This helps identify the specific faulty module.

  4. Replace control module

    Replace the identified faulty control module (such as the ECM). A replacement ECM will likely need to be programmed with the correct software for the specific machine's power rating and configuration.

  5. Clear codes and test

    Clear all fault codes using a diagnostic tool and operate the machine to ensure the fault does not return.

Parts you might need

(4)
  • Blank ECU for JCB 444 T4 engine (Delphi DCM3.3+). Requires programming. Verify fitment by serial number.

  • Engine Control Module (ECM) - Service Replacement

    320/B9535

    Service replacement ECU for 68kW T4F engine. Requires programming. Verify fitment by serial number.

  • Wiring Harness or Connector Pigtails

    Required if wiring or connector damage is found during inspection.

  • Fuses and Relays

    Replace any blown fuses or faulty relays with new ones of the correct rating.

Get help to fix this fault by requesting a quote

Browse other JCB codes