U0110

JCB U0110 – ECU: Inducement BAM TO Fault

Issue description

The Engine Control Unit (ECU) has lost CAN bus communication with the Dosing Control Unit (DCU) due to a Broadcast Announce Message Time-Out (BAM TO). The ECU has not received the expected presence and status message from the DCU within the specified time. Because the DCU controls the Selective Catalytic Reduction (SCR) system's Diesel Exhaust Fluid (DEF) injection, this communication failure triggers Tier 4 Final emissions inducement strategies, which will progressively derate engine power and eventually force a complete shutdown if not resolved.

Applies to these machines

  • JS130
  • JS160

Check the cause

  1. Record and clear fault codes using a diagnostic tool to see if the U0110 fault returns immediately

  2. Visually inspect the wiring harness and connectors between the ECU and the DCU for chafing, corrosion, pinched wires, or loose connections

  3. Verify that all fuses related to the ECU and aftertreatment system are intact

  4. Check for a stable power supply and good ground connections to both the ECU and the DCU, as low voltage can disrupt CAN communication

Repair steps

  1. Check CAN bus termination resistance

    Turn the ignition completely off and disconnect the battery. Measure the resistance between the CAN High and CAN Low wires. A healthy CAN bus should read approximately 60 Ohms. A reading of 120 Ohms indicates a missing terminating resistor or open circuit. A reading significantly lower than 60 Ohms indicates a short circuit.

  2. Check CAN bus voltages

    Reconnect the battery and turn the ignition ON without starting the engine. Unplug the DCU connector and measure voltage on the CAN High and CAN Low circuits (expected 1.5 to 3.5 volts). Check for a short to voltage by measuring between each CAN line and battery positive (should be 0V). Check for a short to ground by measuring resistance between each CAN line and a known good ground (should be an open circuit).

  3. Isolate the faulty module

    If wiring tests pass, disconnect other modules on the same CAN bus one at a time to see if communication with the DCU is restored, though the primary focus should remain on the DCU itself.

  4. Replace and calibrate the DCU

    If all wiring and network tests pass, the Dosing Control Unit has likely failed internally. Replace the DCU with a genuine JCB part and use a diagnostic tool to configure or calibrate the new module to the machine.

Parts you might need

(5)
  • Listed for models including JS130 and JS160 T4F excavators

  • Dm 2.5 Dosing Module

    250/A9105

    Alternative DCU part number depending on specific machine/engine

  • Alternative DCU kit depending on specific machine/engine

  • Wiring Harness and Connectors

    Look up specific part number in official JCB parts catalog by machine serial number if replacement is needed

  • Terminating Resistor

    Replace if termination resistance tests indicate a failed resistor

Get help to fix this fault by requesting a quote

Browse other JCB codes