U0401-61

JCB U0401-61 – Aftertreatment Control Unit or Main Vehicle Controller: CAN Bus Message Error for Modelled NOx from Engine ECU

Issue description

A receiving control module has detected invalid or implausible data coming from the Engine Control Unit (ECU) concerning modelled NOx levels. This indicates a communication error over the CAN bus regarding the calculated estimate of NOx emissions used by the aftertreatment system. On JCB Tier 4 Final engines, this fault can trigger an engine power derate as a protective measure.

Applies to these machines

  • JCB Tracked & Wheeled Excavators
  • Machines equipped with JCB Ecomax Tier 4 Final engines

Check the cause

  1. Use a professional diagnostic scanner to retrieve all active and stored fault codes, noting any other 'U' codes, 'P' codes, or NOx sensor codes

  2. Check the battery and charging system to ensure a stable voltage of 12.4-12.8V at the module supply pin with the ignition on

  3. Visually inspect the wiring harnesses and connectors associated with the Engine ECU, aftertreatment system, and NOx sensors for corrosion, bent pins, frayed wires, or water ingress

  4. With the battery disconnected, measure CAN bus resistance across the CAN High and CAN Low pins (should be approximately 60 ohms)

  5. With the battery disconnected, check for shorts to ground by measuring resistance from CAN High to chassis ground and CAN Low to chassis ground (should be infinite/open circuit)

  6. With the battery reconnected and key on (engine off), measure CAN bus DC voltage (CAN High should be 2.5V-3.0V; CAN Low should be 2.5V-2.0V)

Repair steps

  1. Address Other Fault Codes First

    If any other fault codes are present, especially for specific sensors (like a NOx sensor) or for power supply issues, diagnose and repair them first. Resolving an underlying sensor fault may clear the U0401 communication code.

  2. Perform CAN Bus Health Checks

    Follow the diagnostic checks outlined in the initial checks section to verify the integrity of the CAN bus network.

  3. Isolate the Fault

    If the CAN bus resistance is incorrect (e.g., 120 ohms or 0 ohms), use the 'split-half' method. Disconnect a central module on the CAN network to isolate different legs of the harness. Measure resistance on each leg to determine which section contains the faulty wiring or missing terminator. If wiring is confirmed to be intact, suspect a module failure.

  4. Check ECU Power and Grounds

    Verify that the Engine ECU has a clean and stable power supply and a solid ground connection. Poor grounding is a common cause of communication issues.

  5. Software/Firmware Update

    Check for any Technical Service Bulletins (TSBs) or software updates for the Engine ECU. A known software bug could be the cause, and a reflash by a qualified technician may resolve the issue.

  6. Component Replacement

    If all wiring, power, grounds, and software have been ruled out, the fault may lie with a hardware component. It is possible that a failing NOx sensor is providing corrupted data to the ECU, or there is an internal fault in the Engine ECU causing it to broadcast invalid data. Due to the complexity and cost, the Engine ECU should be the last component to be replaced after all other possibilities are exhausted.

Parts you might need

(2)
  • NOx Sensor

    Varies by machine. Check for specific fault codes related to the NOx sensors themselves before replacing.

  • Engine Control Unit (ECU)

    Varies by engine model (e.g., Delphi). Must be programmed specifically for the machine's VIN and configuration.

Get help to fix this fault by requesting a quote

Browse other JCB codes