U0401-81

JCB U0401-81 – Engine ECU: CAN Bus Message Error from Engine ECU

Issue description

A control module on the machine's Controller Area Network (CAN bus) has received invalid or implausible signal data from the Engine Control Unit (ECU). This indicates a communication issue within the CAN bus network originating from the engine's computer. If left unresolved, this fault can lead to the engine entering a reduced power mode (engine derate or T4F Inducement) to prevent potential damage.

Applies to these machines

  • EcoMAX engines
  • Dieselmax engines
  • Tracked and Wheeled Excavators
  • JS115
  • JS130LC
  • JS145LC
  • JS160 T3
  • JS200
  • JS220
  • JS240
  • JS290
  • JS330-JS500 Series
  • Telehandlers

Check the cause

  1. Use the JCB Electronic Service Tool to read all fault codes from all modules to identify any sensor-specific faults that might be causing invalid data.

  2. Inspect the engine wiring harness (EH) and all related connectors for chafing, cuts, crushing, or routing issues.

  3. Disconnect and inspect the ECU connector pins and terminals for corrosion, moisture ingress (especially after pressure washing), bent or loose pins, and ensure the seals are in good condition.

  4. Check that all machine and engine earth (ground) connections are clean, tight, and free from corrosion.

  5. With the ignition off, measure the resistance between CAN High and CAN Low wires at a diagnostic connector (should be approximately 60 Ohms; a reading of 120 Ohms indicates an open circuit or missing terminating resistor).

  6. Verify the presence and condition of the CAN bus terminating resistors (120-Ohm at each end). Note that for Dieselmax engines, termination is not within the ECU but is an external component on the engine harness (e.g., CAN RESISTOR C18_EH).

  7. With the ignition on and engine off, check the voltage on the CAN lines (CAN High and CAN Low should both read approximately 2.5V when idle).

Repair steps

  1. Address other faults

    Diagnose and repair any other ECU or sensor-specific fault codes first, as they could be the root cause of the invalid data being sent over the CAN bus.

  2. Perform physical repairs

    Repair or replace any damaged wiring harnesses, connectors, or grounding points found during inspection. Ensure all connections are clean, secure, and properly sealed.

  3. Isolate the fault

    If wiring is intact, disconnect modules one by one to see if the fault clears. This can help isolate a faulty module or terminating resistor on the network.

  4. Check and replace terminating resistors

    Locate and test the CAN bus terminating resistors. If a resistor reads significantly different from 120 Ohms, replace it.

  5. Replace Engine ECU

    If all other possibilities have been exhausted and the fault persists, the Engine ECU itself may be faulty. Replace the ECU and program it to the specific machine.

Parts you might need

(6)
  • Engine Wiring Harness

    721/12138

    For JCB Excavators JS145LC, JS115, JS220, etc., with Isuzu 6HK1 engine

  • Engine Wiring Harness

    320/09953

    JCB Engine Harness

  • Cab Wiring Harness

    332/J3663

    For various JCB JS Excavator models

  • CAN Bus Harness

    727/00009

    JCB HARNESS CAN 540 LG BHEAD

  • CAN Terminating Resistor

    Referred to as C18_EH in some diagrams; source based on specific machine's parts catalog

  • Engine Control Unit (ECU)

    Highly dependent on machine and engine model; requires sourcing via serial number

Get help to fix this fault by requesting a quote

Browse other JCB codes