U0401-86

JCB U0401-86: Invalid CAN Signal From Engine ECU

Issue description

A receiving control module on the CAN bus has received invalid, corrupted, or out-of-range data from the Engine ECU. The '-86' suffix specifically indicates an invalid signal rather than a complete loss of communication. This communication error can be triggered by electrical system issues, CAN network wiring faults, or a primary fault within the Engine ECU or its sensors providing faulty data.

Applies to these machines

  • Tracked and Wheeled Excavators (JS Series)
  • Loadalls
  • Machines with JCB EcoMAX Tier 4 engines
  • Machines with Stage V engines
  • Any JCB machine using the J1939 CAN protocol

Check the cause

  1. Perform a full system scan using a diagnostic tool like the JCB Electronic Service Tool to check for all active and stored fault codes in every machine module, especially primary Engine ECU faults (P-codes) or other network codes (U-codes)

  2. Check battery voltage (minimum 12.4V for 12V systems or 24.8V for 24V systems) and verify charging system operation

  3. Inspect all main power and ground connections, particularly the ECU power supply and chassis/engine ground straps, for corrosion and tightness

  4. Visually inspect the CAN bus wiring harness for chafing, melting, pinching, or physical damage

  5. Unplug and inspect connectors at the Engine ECU and the module logging the fault for green corrosion, bent pins, loose pins, or water/debris ingress

Repair steps

  1. Isolate the fault condition

    Determine if the fault is intermittent or occurs during specific operations to help narrow down the location of a wiring issue.

  2. Perform CAN bus resistance test

    With ignition and master switch off, measure resistance between CAN High and CAN Low. A healthy bus reads approximately 60 ohms. A reading of 120 ohms indicates an open circuit or missing terminating resistor, while significantly less than 60 ohms suggests a short circuit between the CAN wires or a faulty ECU.

  3. Perform CAN bus voltage test

    With ignition on and engine off, measure voltage between CAN High and chassis ground (expected 2.5V to 3.0V), and CAN Low to chassis ground (expected 2.5V to 2.0V). Voltages outside these ranges indicate a short to power or ground on one of the CAN lines.

  4. Isolate faulty modules

    If bus wiring is intact but resistance or voltage is incorrect, disconnect one module at a time with power off and re-check CAN bus resistance to identify if a specific module is causing the network fault.

  5. Replace Engine ECU

    If all wiring, terminating resistors, and other modules have been ruled out, the Engine ECU may have an internal fault preventing it from sending valid data. Replace and program the Engine ECU to the specific machine.

Parts you might need

(4)
  • Engine Control Unit (ECU/ECM)

    Requires programming to the specific machine. Obtain exact part number via serial number.

  • Wiring Harness

    Replace if CAN bus harness sections are damaged beyond repair.

  • Connectors and Pins

    Use for repairing damaged ends of the wiring harness.

  • CAN Bus Terminating Resistor

    Replace if missing or faulty (may be integrated into an ECU on some systems).

Get help to fix this fault by requesting a quote

Browse other JCB codes