JCB U0401-87 – Transmission controller or main vehicle/chassis control unit: Invalid Data Received From Engine Control Module (ECM) - Missing Message
Issue description
The fault code indicates that a control module on the machine's Controller Area Network (CAN) bus has detected a loss of communication from the Engine Control Module (ECM). The '-87' suffix specifies a 'Missing Message' failure, meaning expected data packets from the ECM are not being received by other modules on the network. This communication error on the J1939 data bus can lead to reduced engine power (limp mode), illuminated warning lights, and the deactivation of certain systems like traction control.
Applies to these machines
6 machines- 3CX
- 4CX
- 535-95
- 540-140
- JS Series
- EcoMAX Tier 4
Check the cause
Use a diagnostic scanner to check for all active and stored fault codes in every machine module to help pinpoint the root cause.
Check battery and power supply voltage (should be 12.4-12.8V when off, and 13.5-14.5V when running) as low or unstable voltage can corrupt module operation.
Inspect all main battery and chassis ground connections to ensure they are clean, tight, and free of corrosion.
Perform a CAN bus network health check with the machine's power completely off (disconnect the battery to ensure the network is asleep) by measuring termination resistance between CAN High and CAN Low (should be approximately 60 ohms).
Visually inspect the wiring harness between the ECM and other machine modules for chafing, pinching, corrosion, or heat damage, paying close attention to articulation points.
Repair steps
Address basic power issues
Correct any low voltage or bad ground connections found during the initial diagnostic checks. Clear the fault codes, operate the machine, and see if the code returns.
Isolate faulty CAN circuit
If the CAN resistance reading was incorrect (not 60 ohms), use a split-half method by disconnecting modules one by one to isolate sections of the harness until the faulty leg (missing resistor, short, or open circuit) is identified.
Repair wiring harness
If a wiring fault such as a short, open circuit, or corrosion is found, repair the affected section of the harness and ensure all connections are clean and secure.
Check ECM power and ground
If the CAN bus wiring and termination resistance are correct, verify that the Engine ECU itself has proper power and ground directly at its connector.
Isolate the ECM
If all wiring and power supply checks pass, disconnect the ECM and check if other modules on the network begin communicating with each other to determine if the ECM is pulling the network down.
Replace Engine ECU
If the ECM is determined to be the source of the fault and cannot be repaired, replace it. The replacement ECM will require programming to the specific machine's serial number and configuration.
Parts you might need
(7)Example part for JCB engines. Must be cross-referenced with specific machine build.
Engine Control Module (Cummins CM850)
4921776Example part for JCB engines. Must be cross-referenced with specific machine build.
Engine Control Module (Cummins CM2250)
4993120Example part for JCB engines. Must be cross-referenced with specific machine build.
120 Ohm Resistor
CAN bus terminating resistor, located at each end of the main CAN backbone.
Wiring Harness / Connectors
Engine or Chassis Wiring Harness, Deutsch Connectors. Part numbers are specific to the machine model.
- Control Steer Mode ECU728/30000
Example of another module on the bus. Fits various 3CX, 4CX, and Loadall models.
Livelink Module
728/C6423Telematics unit; known to cause CAN bus issues if water-damaged. Part number is an example and must be verified by serial number.
Get help to fix this fault by requesting a quote